©ASUSTEK COMPUTER INC. ALL RIGHTS RESERVED.

FelixFFM · 07-22-2016

https://www.youtube.com/watch?v=km1LI3CiGQgAt 3:20 you can see several features that I found to be unavailable to buy or to enable in the current AURA lineup. These are:- Graphics card/motherboard/LED strip sync- RGB LED on monitor base, syncedCan an...

FelixFFM · 10-09-2016

It works for me. Sure that you plugged it into the correct input? Headphone and not mic? Maybe your front panel is connected to the motherboard in the wrong way.Also, after you set up the impedance, it will also use it for the rear jack on the mother...

FelixFFM · 07-29-2016

Can anyone confirm if it's even possible to set the wifi band to 5ghz on the Hero Alpha wi-fi adapter? Someone on Windows 8.1 maybe?

FelixFFM · 07-24-2016

I have the exact same issue, thanks to CyberCub I could install the windows 8.1 driver. That helped me at first, I could set up an AP and steam link worked fine.However, during the day, WIFI interference is too high, leading to packet loss.To avoid t...

FelixFFM · 07-23-2016

I really doubt that it will have any measurable impact. The fans will likely have their own power circuit that is independent from the (very sophisticated) GPU power setup. Same goes for the LEDs on the card.

FelixFFM · 07-22-2016

It blows air outwards, it's exhausted into the case, so good airflow is important. My card gets hotter when I have the case open, and stays cooler when it's closed.Generally, exhaust fans are more effective with this scenario, as long as you have one...

User Statistics

User Activity

ROG SWIFT monitor with synced AURA RGB LED?

Re: Sonic SenseAmp not detecting headset impedance/no amplification

Re: Maximus VIII Hero Alpha - WiFi Engine

Re: Maximus VIII Hero Alpha - WiFi Engine

Re: Strix 1080 4-pin connectors faulty?

Re: Strix GTX 1070 Fans Airflow