I am putting together a new PC and have run into some trouble.
Rampage IV Extreme
2 water pumps, tanks and radiators
Corsair AX 1200 gold
Plus a lot of sensors that will connect to the Aquaero
I have connected the Aquaero and the fans and it runs fine, but when I connect the motherboard and the graphics cards and 1 HD it only gets 5v standby power. If I disconnect the MB, HD and graphic cards I still only get 5v SB. Have to disconnect the power cord for some minutes (haven't timed it) before full power returns. Then running Aquaero is ok, but the second I reconnect the MB it turns off.
The other day I found a 30v mosfet regulator on the bottom of the case, but quite sure it's for the PSU tester (molex output isn't working) as it is produced for iPhone and iPad.