I have randomly a problem with Code 62, a Black Screen and the VGA LED off, as though the board would not recognize the Graphicscard.
Here is ma system:
Asus Rampage IV Extreme
I7-3930K @ 4,2GHZ - Vcore 1.28
Asus HD7950DCII Top @ 900MHz
4xKingston Hyperx Blu @ 1600 - 1.575 Voltage
2XCorsair Force GT in Raid0 on X79 Chipset
Hope this is enough.
Actually I allready send in an Asus Graphics card because of this problem. I was sure that the HD7950 was the problem, because I couldn't get a Videosignal and the board told me that no card is installed (VGA LED off).
I recieved a new card and now it's the same problem.
A few points:
1. Usually it happens when I turn on the PC. No screen and often after a few reset everything works fine again. I tought could boot, but on the Rampage this should not be a problem.
2. It does not matter whether I clear the cmos and run everything in original, because even then this problem occurs.
What could it be?
I read the following thread but no solution available: http://rog.asus.com/forum/showthread...2-VGA-Q-LED-on
Can anyone help me out?