Today I was tidying up the cables from the computer, then when I gave him power, he went to the OS,
because I heard the sound of windows starting in the columns, but gave me no signal on monitor.
I tried connecting another cable (Hdmi) but remained in the same.
I try resetting the cmos a few times and now he does not post, after doing the first beep it shows
the debug led code 62, then switches to A2, and finally, sometimes he stays in the code 34, other in AE.
He also shows me the red light in boot device led, I made sure that all cables are properly.
I removed the graphics card and put it back again, I tried to start the computer with only one
memory module, but no luck.
I read somewhere if turned off the rog button could solve the problem, but don´t work for me!
(I have the computer will have five months, he never gave me problems, and always
showed me the debug LED AA)
This is my rig:
Maximus IV Extreme Z
Intel I7 2600k
G. Skill Ripjaws 8GB DD3 1600Mhz CL6
Asus GeForceGTX 580
OCZ Vertex 3 120GB SataIII
WD Caviar Green 500GB 32MB 7200rpm (X2)