Fan plugs

[UnfocusedAsus]

Oh, OK. I saw Myk's comment about PWM and followed that. Yeah I'm not sure anyone makes a 3 pin fan to 4 pin molex adapter. People would be tempted to run things other than fans on the fan headers with such an adapter and would cause damage. Honestly I would just cut the molex off and put a proper fan plug on the fans. The connector is smaller and you can also use a fan controller if you wanted. And there are plenty of adapters going back to molex if you ever needed to do it that way. You could even sleeve the fans while the connector is off.

Any ideas where I can get those connectors? Also besides cutting the one connector off how do I attach the new ones?

[xeromist]

After cutting the connector you strip maybe 2mm of insulation from the end then you crimp these on with needle nose pliers:
http://www.frozencpu.com/products/12...tl=g44c155s323
Ideally you want enough stripped so that the first crimp grabs the bare wire and the second grabs the insulation. Then you snap the pins into one of these plugs:
http://www.frozencpu.com/cat/l3/g44/...ml?id=BtUTSbXX
Make sure to confirm power & ground before plugging them into the connector so the plug is wired properly.

If you want to sleeve the fan then there are many options. Basically you need some sleeving and then some heat shrink on each end of the sleeving to anchor it and keep it from fraying.

[UnfocusedAsus]

Awesome. I might order some here.

Now is there going to be a problem if my fans are two wire?

[xeromist]

Awesome. I might order some here.

Now is there going to be a problem if my fans are two wire?

No, it just means you won't have the speed sensor wire.