09-05-2012 09:59 AM - last edited 3 weeks ago by ROGBot
09-05-2012 10:05 AM
09-05-2012 10:09 AM
Krindor wrote:
If you haven't try clear cmos, worked for me
09-05-2012 10:15 AM
09-05-2012 10:45 AM
09-05-2012 11:12 AM
HiVizMan wrote:
What I would suggest is to remove all the hardware from your motherboard. Leave the CPU in for now.
Then fit only the bare minimum to post to BIOS. That means no hard drives or SSD please.
Basic set up should be something like this.
Keyboard and mouse.
VGA
and one stick of ram in the furtherest slot from the CPU.
Ensure that all the PSU connectors are fitted pay extra note of the CPU 12 V connectors.
You can also try your B BIOS and the go mem button before you strip your system.
09-05-2012 12:09 PM
09-06-2012 06:12 AM
HiVizMan wrote:
What were the Q-code (LED poster) during the process? Where did it stick?
When you say checked I hope you mean you did exactly as I asked. 🙂
09-06-2012 06:21 AM
09-14-2012 07:18 AM
HiVizMan wrote:
Thank you.
Assuming you have all your PSU power connectors seated correctly especially the 12v CPU connector...
I suggest that you RMA the board