This is as she stands right now next to me as I am waiting some parts. 😞 Those ugly rads hanging off the back will go bye-bye when I get the external 1080 box as will that 240 sitting in the bottom because I get to put a 2nd PSU there 😄
Well... Putting this thing back together again slowly since I had to RMA my mobo for a DIMM A1 slot failure. Board comes in next week because my vendor was out of stock otherwise I would have received sooner...
Here's a teaser... 3x290X + 3x EKWB Blocks... I still have to leak test the stack.
Also switching mouse to Mionix Avior 7000. Have a Tripp-Lite LC1800 Line Conditioner on order too...
Scratch this... Going QUADFIRE 290X and taking most of the Alphacools out and selling them. Going Phoyba Game Changer 1080 External Rad in a box.... Stay tuned!
leak test before putting inside the case, just put the tubes in top as it stands now and its easyer to see if you have a leakage now and you can see from where too if so. harder to do inside the case.
I know. I am going to test the GPU stack for 4 hours before I do the entire system leak test. The External 1080 rad + rad box comes Tuesday. Unfortunately I'm still waiting on a 1300W eVGA PSU (Stock issues) I'm using exclusively for the GPU stack and my mobo is still out for RMA because my vendor was having more stock issues. GRR!!!
Alphacool UT60 140mm radiator 1x XSPC Xinrulian 1650rpm 140mm fan ModMyToys for Monsoon Carbon Fiber fittings Monsoon rotarys with custom red disk accents Open hole for a bitspower temp fitting
Note the Dual PSUs in the bottom. I am just waiting the quick disconnects for my external rad and the UT60 140mm which come tomorrow then it's going to be done!!!! It runs however but I have to turn my 2 through 4th PCI lane off. I don't have the rad space to dissipate the entire 290X stack hooked up yet... Don't want to hook it up until I get quick disconnects or it's going to be insanely awkward and heavy to drain and set up again.