1mluer
05-11-2019, 11:45 PM
This is a very good cooler.
In fact my cooler score is 187 and was going up from 185 on my ROG Maximus XI Apex and a super clocked i9-9900k. 5200ghz
It cooler barely fit in my case as the water tubes were almost too short. So check how far you have to go from where you will mount the radiator before you purchase. It could use at least 2 more inches on the hoses. If it weren't for the push - pull configuration on the fans I setup, It would not of never fit in my In-Win 909 Case. Additionally the cold plate and housing is taller than normal too so if you are barely making it past cutout's in your case now with other coolers, you will have to modify the case. I needed 1/4 inch more to allow the housing to pass so I used my Dremel.
Other than that, man it does do the job.
In fact my cooler score is 187 and was going up from 185 on my ROG Maximus XI Apex and a super clocked i9-9900k. 5200ghz
It cooler barely fit in my case as the water tubes were almost too short. So check how far you have to go from where you will mount the radiator before you purchase. It could use at least 2 more inches on the hoses. If it weren't for the push - pull configuration on the fans I setup, It would not of never fit in my In-Win 909 Case. Additionally the cold plate and housing is taller than normal too so if you are barely making it past cutout's in your case now with other coolers, you will have to modify the case. I needed 1/4 inch more to allow the housing to pass so I used my Dremel.
Other than that, man it does do the job.