PDA

View Full Version : Asus Rog Z270E ram problem slot B



barno78
03-19-2017, 02:34 PM
I do not know what the problem is put memory into slot B, and the computer will not turn on, like slot B was dead, my memory is a framework Corsair 16GB (2x8GB) 3000MHz DDR4 CL15 Vengeance LPX

Someone knows how to solve?

FuryA
03-20-2017, 08:56 AM
hi barno
some steps of troubleshooting You may try, clean CMOS and
push Me button then try to clean the Vengeance LPX pins
and re install again

barno78
03-21-2017, 04:39 AM
On this motherboard there is no ME button, and how do CMOS restet do?

Silent Scone@ASUS
03-21-2017, 07:31 AM
On this motherboard there is no ME button, and how do CMOS restet do?


As per the manual the CMOS jumper is located in the bottom right segment of the board and is referenced as RTC Clear Data.


1) If any of the onboard LED are lit (e.g. CPU, DRAM)
2) Remove the CPU whilst checking for any bent pins, reseat the CPU whilst checking for even mounting pressure and over-tightening.


63370

barno78
03-21-2017, 02:33 PM
OK pin is simple under processor I checked the CMOS reset I did and continue the same, lit the led yellow moments and then the red CPU and DRAM lit up, and so on to change as the out of the B slot the computer will turn on normally, who else has any ideas?

barno78
04-13-2017, 05:53 PM
Can someone help me with this still haven't found solution....