I think adaptive + offset is broken. You need to set the voltage to manual. Have you tried pulling the power cord, holding down the power to discharge capacitors ? Try resetting CMOS or pull the battery for 5-10 minutes again so you can get back into...
Well, either way, I had to up the vcore to pass both the benchmark and stress test from 1.370v to 1.385v. Then I reinstalled Windows. Everything is fine....now
Most people don't benchmark/stress test with the screensaver enabled just to see if it will crash the system on purpose. I just don't get it....Please don't take it the wrong way, but I just don't get it.
MMikhail wrote:SOLVED!RealBench 2.44 causes false positive instability reports when Windows ScreenSaver engine is enabled.Solution:Use RealBench 2.53b, has build in temperature monitoring and works! Peace of mind and finally relax (Took numerous h...
I had the same issue today. I had to pull the thumb drive out before the 1st reboot. Then all went along normally. Have you checked the CSM settings? I set "boot for storage devices" to UEFI first and "Secure boot" to Other OS, since I installed Wind...