Has anyone else had problems with the bios 1801 update? I tried it and I could not boot up with that bios at all and was forced to boot from Bios2 and then reset everything back to bios update 1701.
I was playing around with the Asus PC Diagnostics tool and noticed I would get a failure during the RTC Accuracy Test. What does this mean and is there a way to correct it?Thank you.
I built my system a few weeks ago. Bios saw 32GB of RAM fine. Had and seem to still have stability issues since the build. Many times would have to clear CMOS to get the PC to get to BIOs and then to Win 10. I updated the bios to 1701 today and as...
New build was working fine for over a week. Loaded printer software and MyCloud software and rebooted and then no display. Noticed error code 76. What does it mean and what is most likely wrong?Thank you,
Updated with bios 3202. Ran into problem where PC would only boot to the bios. Discovered that my boot drive wasn't listed and had to boot from F8. Changed boot setting to boot from proper SSD. Discovered another issue that may have been created wh...
I was having problems with my system freezing too. I was overclocked to a point I thought was stable and when I would try to access an external hard drive Windows 10 kept freezing or crashing. I have since played around with the OC settings and ran...
I replaced the CMOS battery and rebooted and retested the RTC and it still fails. I don't really have any other symptoms except for the standard occasional instability issues that pop up occasionally. I am not sure if this ASUS PC Diagnostic tool i...
I removed, not disconnected, the Corsair RAM fans from my RAM and powered up. Low and behold the 32GB of RAM showed up in the bios. I have the Corsair Dominator Platinum DDR4 RAM and the stock fans are very tight up against the back plate of the Ti...
Thank you for the tips. Why would there be bad pins in my CPU if when I first powered up the system a few weeks ago it saw 32GB of RAM? I tried setting the vdimm to 1.4 with no change in results. Tried setting manually, not using XMP, and setting v...
