HI all I am at present way behind with my bios 1401 I think, never done it before got the latest for my m/b on flash drive, now my question is I am at present running at 4.6, do I have to clear c/mos and return to stock 4mhz before I s...
pc working fine for weeks ,at 4.5 i7 with 32 gbs fury hyper x. ddr4 2666 mhz this morning for no reason I can see no boot. looked up q codes 1st was 32 after a reset and clear c mos 99 I then replaced with 16 gb g skill 3000 MHz which I had spare...
hi all newbie here just joined wishing you all well can anyone explain this please all inputs welcome, did overclock to what I wanted 4.6 in bios. xmp sync all cores set my voltage to 1.270 set on manual all my other settings were ok exit. ...
oh I thought you were supposed to keep up , thought the updates gave more stability, I am only on 1401 it is now 3002 I am fairly stable at 4.6 ill hold of see how it goes
results, done the test on the ram/ 16 gb in 1and2 ok/ other 16 gb in 1and 2 all ok, all four 32gb in 1234 tested all ok booted up fine as normal, looked in event for the results but at my age a bit above my pay grade lol. now could the no boot h...
NemesisChild wrote:Do not split the sets, run each set in each dual channel configuration.However, it's not advisable to run mixed sets of memory, even if it's the same brand & model.Did you try booting/posting after returning the bios settings to st...
my modules are the same 15-15-15-35, I have had a very close look at the labels. they seem to be two16gb kits would I be better using ie,. 1-3and2-4 splitting the two kits that way also I , keep getting a notice I have never seen before this is...
