Hi folks,Can someone suggest a way to utilize the Gen 2 connector (#11), like an adapter? My case has 4 USB 3 front connectors wired to two cable ending with two 19-pin Gen 1 connectors (#13), and now I can use only 2 of them.
Seeking the community help on this issue. For some reason my Samsung 860 PRO 256GB is very slow and I was unable to find the reason why. Sequential read 251MB/s, Sequential write 155MB/s.Any ideas?
Hi there,My first post here, but not my first Asus MoBo. I have been bulding machines based on Asus MoBos since late 90ties.To the specific matter I am seeking the comunity advice: I need 64Gb on Crosshair hero viii with 3950x for content creating...
OK, it was the board. Here are the test results after replacing it: https://www.userbenchmark.com/UserRun/34197018Some of the REDs are not good, but I can live with this for now Thank yoou all for the help. Cheers!
RedSector73 wrote:Userbench does not like Nahimic Service. In services tab find it and stop it than put to manual from automatic and complete the test, this will stop it causing userbench to cry foul. I have a look through the data now.Well clearly ...
RedSector73 wrote:Can you post what chipset drivers you are using, device manager - disk drive ?Also device manager - IDE ATA/ATAPI ACHI Controller ?Screenshot's might be easier.Also can you run a userbench test and then post me a link to the test re...
Legolas wrote:Good that you tested different drives on the different slots, which eliminate the drive as the root cause. If it was the software, if you uninstall the software, does the speed not change or it is still poor performance? If drive have ...
