Guys, is there anyone out there that can give me a walkthrough guide on PState overclocking so I can get my 1920 to downclock when it’s not doing anything, many thanks for any reply’s*
Is anyone using the new EK mono block with the new cold plate, I’m just wondering what the performance is like now compared to the old block and compared to the XSPC block*
To get my 1920x to 4ghz and my memory to 3200mhz I have to have my Soc volts set to 1.2 in the bios and where it’s showing manual mode it says it’s at 1.242v is this safe? When in windows HWiNFO64 says it’s @1.194v and AIDA64 says 1.243v which one sh...
Guys just a quick question what temps should my VRM’s be reaching with a 4ghz OC 1.4v vcore 1.2V SOC? I monitor my temps and have never seen my VRMs get over 70c under heavy bench and when gaming never get a over 50c. Also what is the PCH? Those temp...
Arne Saknussemm wrote:Hmm that is a bit outside of my comfort zone for sure68C is the AMD recommended max temp and 1.425v the max vcorehttps://rog.asus.com/forum/showthread.php?100440-Arne-s-Guide-to-OverClocking-Happiness well I managed to get some...
Arne Saknussemm wrote:Hmm that is a bit outside of my comfort zone for sure68C is the AMD recommended max temp and 1.425v the max vcorehttps://rog.asus.com/forum/showthread.php?100440-Arne-s-Guide-to-OverClocking-Happiness I have read you can disreg...
Arne Saknussemm wrote:Auto is good...if you set it to 3 it will send SOC even higher...my board must be backwards because level 3 is keeping it at what I set*