HiI have just finished my new build, however I have an issue with the rear usb 3.0 ports. I have a usb 3.0 enclosure attached to one of the ports and the transfer speeds are only between 20 and 30 MB/s. If I attach the same enclosure to my front ...
You'll need to work out the cfm of your fans, to get positive pressure you'll need to have a higher intake cfm. My current setup is 2 fromt 140mm intakes, plus a 120mm at the bottom. Then a 140mm exhaust at the rear and 2 140mm at the top exhausti...
So I enable better performance while the drive was attached to the front ports and speeds went upto ~200Mb, which is good. I updated the chipset drivers and rebooted and plugged the drive into the rear port again and speeds are now the same as the f...
Thanks, I've already updated the Bios to the latest version. I'll try the chipset drivers later when I get home from work. I usually only install them if there are exclamation marks in device manager