Search:

Hi livedash screen that code is what this means. But this code writes as the system opens normally. MF11 board.

'fast start up and hibernate disable. experimented for a long time. same problem re-done after 4-5 days.

All I / O tools were removed. It exhibits the same behavior. Xmp disable.

Yes windows 10,
I don't think it has anything to do with hibernation. The Qcode display shows 00 and the system fans are running at the last cycle. The motherboard LEDs are lit solid. Everything...

Hi, sometimes not too often. When I turn off the system, the motherboard shows 00 qcode and the system does not shut down. It stays attached. I force the PSU to shut down by turning off the...

Hello there. I have a problem. When opening the windows, the mauses will be snapped. The device comes with a new device. its maus logitech g502 rgb mainboard apex x.all drive bios up to date.

I solved the problem. With a newly purchased USB memory. Usb memory behaves when choosing. thanks.

I took out all the 3rd party tools. I tried the same result

yes usb appears as mbr disk in fat32 format. The file has been renamed M10A.CAP.

Hello there
I crossed the Formula Series. I am using asus maximus x apex. I want to go back to 1401 bios from 1801 versions. Or want to update the same version again. But the usb bios flashback...

On page 4, I explained the ram stable distortion. I'm not keen to upgrade the bios. but the 1601 bios does not serve to clean the nvme drivers. secure eraese does not work. There are 960 and 950 pro...

After version 1602, the memory stability of the F4-4000C18D-16GTZR x apex disappeared. while the other place is being broken. I can't tighten the timings of high MHz anymore.

the problem is that in xpm profile the system is switched off and on and the automatic i / o s / a voltage is adjusted and at both it is almost 1.3v. I do not know whether the system will be unstable...

There is a balance between CPU frequency and ram frequency. How high is the maximum MHz ram speed with the CPU with 5.2GHz speed?

I know just to give the right to pieces by pushing the boundaries. :). unfortunately we do not use any hardware until we lose it quickly. due to renewed systems every year. The safe setting for me...

Thanks for the answers. you think performance is slow at these speeds. I understand. That's all I can do.

Can we be stable? I / O and s / a volts 1.4 continuous. xmp activates itself. it will not be stable. do these settings cause system corruption?75137

what set problem is solved? are you going to tell. You seemed very helpful. but you have not answered anyone's question !! ??

If xmp auto-opens, IO / and sa / volt75047 automatically rises to about 1.35- What is the safe interval for 7/24.

74887
How did you set rtl and Io-l. Take a bios image. also the ram voltage is out.

prime 95 which run the test.

GSKILL F4-4000C18D-16GTZR There is a compliance issue with ram. Overclocking capability is down. Also, in the raid setup, if you disable csm from bios, the system crashes. While fast boot is...

report....firmware update need!

Sometimes there is an oddity that prevents the system from closing. it does not control the fans.

fenvi 8802 pcıe wifi support maximus x apex ?