Search:

Type: Posts; User: GEEKCPA

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: Pg27uq

    by GEEKCPA
    Replies
    1,646
    Views
    273,988

    The delay doesn't inspire much confidence in the...

    The delay doesn't inspire much confidence in the quality of the product whenever it is released. ASUS will likely say they delayed to make sure the product is right when it comes out, but I think a...
  2. Replies
    6
    Views
    6,339

    I just updated two older computers to 1.83 from...

    I just updated two older computers to 1.83 from 1.81. It doesn't show RAM information on either PC now, but did on 1.81. One computer is running Windows 7, the other is still on XP. I bet its an...
  3. Replies
    13
    Views
    2,143

    Suggestion

    Get a UPS with "Controlled by Master" outlets. Connect the monitors to two of the "slave" connections and the PC to the Master. Some UPS's may require software to configure the unit to turn the...
  4. In your BIOS setup have you listed the onboard...

    In your BIOS setup have you listed the onboard video as the first video source? Not sure exactly where it is in the BIOS, but you have to enable the onboard video for it to work.
  5. Replies
    10
    Views
    1,887

    show piece

    I want to show it off to myself. It won't be my main work computer, as I have my R5E with a 5930K @ 4.1 and 64 GB of Dominator 3200 and two Matrix 290X in Crossfire for that (and a few games)....
  6. Replies
    10
    Views
    1,887

    Too much pressure?

    It would appear I applied too much pressure when the tubing cracked, but I only turned the knob 1/8 or 1/16 turn or less and rotated completely around the tube two or more times before tightening...
  7. Replies
    10
    Views
    1,887

    Dedicated measuring equipment?

    The measurement seems to be my biggest problem, and getting the bend in the right spot. What is this equipment you mentioned, and where did you get it?

    I'm just using a small ruler or tape...
  8. Replies
    10
    Views
    1,887

    Water cooling forum?

    I asked the question here because I think most users of this MB are expert about computers, and about water cooling specifically. Other than my AIO cooler on my R5E, I haven't used water cooling...
  9. Replies
    10
    Views
    1,887

    Use a filter with Mayhems Aurora Silver?

    I'm at the stage in my build where I'll be cutting and bending tubing. I plan to use Mayhems Aurora Silver, and noted on the bottle they recommend using a filter. Is this really required? If I...
  10. Replies
    95
    Views
    24,562

    To find out you Windows version press the Windows...

    To find out you Windows version press the Windows key + R for "Run", type in "winver" (without the quotes) and it will display a screen telling you the version and build #
  11. Just an FYI

    My FCU Start Button issues only stayed solved for 2 days. Last night I was away from the computer for about 2 hours. When I cam back the screen had turned off according to my power plan, but when...
  12. Replies
    7
    Views
    13,323

    See this:

    http://www.tomshardware.com/answers/id-3398956/rgb-fans-working-asus-aura.html
    More about rgb fans working asus aura. Best answer. Atomic_Subwave Apr 27, 2017, 9:07 PM. The Aura Sync page on Asus's...
  13. Replies
    95
    Views
    24,562

    12V vs 5V

    I just checked my cards. The RGB header has red blocks and are clearly labelled 12V, G, R, B. I plan to connect the Phanteks water block's RGB lead there and and then use the splitter on that...
  14. How to tell if I got 1709?

    I used media creation tool to download Windows 10 and create a bootable USB drive. How do I know if what I have on the stick is 1709 (FCU)? There was no statement or indication which version I...
  15. a couple of answers

    There are some things in your questions I'm not sure of...yet...because I've not set my R6E up yet, but I'll give it a shot.

    1) I believe you can boot from a Samsung NVMe drive in either of the...
  16. Replies
    95
    Views
    24,562

    4-pin RGB on cards?

    My 1080 Ti's each have a 4-pin connector that I think can be used for the Aura RGB, wouldn't it work just as well to attach the bridge cable there? If I can shorten wire paths I hope to be able to...
  17. Replies
    95
    Views
    24,562

    qUESTION ABOUT sli BRIDGE

    How do you have the SLI Bridge cable attached? Is it to the MB or to one of the video cards?
  18. FCU ISO download

    Is it recommended to download the ISO with the FCU and do a clean install on the R6E? Or is it better to install from the OEM CD and hope the "upgrade" to FCU doesn't trash the system? Is there a...
  19. Got it working

    I went through the five most recommended (apparently) solutions again, one at a time with no success. Until...I rolled back my AMD video drivers to the previous version. Creating a new user finally...
  20. Where to download F6 drivers?

    Do you have a link to download these drivers? Do these drivers allow the use of 960 Pro drives in Raid 0? (Doesn't matter if the Raid array is bootable on Dimm.2 card)
  21. FCU problems on R5E as well

    My R5E is having the dreaded Start Button problems after the FCU update. I've tried all five of the most common "solutions" and none of them work. Added a new user, which took 25-30 minutes, and the...
  22. Replies
    5
    Views
    1,440

    Found them

    I was able to remove the two screws and anchor the remaining MB screws. Now I'm all mounted. Working now on modding the case for smoother cable pass-throughs and radiator mounting to move the top...
  23. Replies
    5
    Views
    1,440

    Mounting the R6E to case

    I've started my test fitting of the R6E to my TT View 71TG. I don't see a way to anchor the motherboard to the case using the middle set of stand-offs. To acess these mounting holes I would have to...
  24. Replies
    2
    Views
    2,004

    Try a different DP cable

    You may have a bad cable. You should be able to select 3440 x 1440 @ 60 hz. Or uninstall/reinstall both monitor and video card drivers.
  25. It would be nice if Aura would allow you to...

    It would be nice if Aura would allow you to exclude detected items from its control. I'm just starting my build so not even close to starting it up, but I have the Corsair Vengeance 64GB kit...
Results 1 to 25 of 44
Page 1 of 2 1 2