Search:

Make sure you're using the latest chipset drivers and use Samsung Magician to check for the latest firmware on the NVME drives.

Hello,

Q-CODE 0D is memory training.

Some kits may require more voltage due to the guard band put in place by the memory vendor not being adequate for other platforms. You can try 1.4 to 1.45v...

Hello,

Are you able to provide the URL you were using?

Hello,

1) I would recommend using Karhu Ram Test over HCI. Far easier to use and more stringent test of stability.

2) First gen Ryzen Fabric is not as strong as later iterations, frequency is...

Hello,

ROG Care is the intended subsection for issues affecting certain products and is more likely to be picked up by CS and internal staff, hence why it was moved. However, if you would prefer...

This issue has been identified with certain browsers, should be resolved shortly.

Hello,

It should be possible to set a custom fan curve to bypass this if one is using multiple high refresh displays. Also, as stated by another user make sure there aren't any applications...

I'm not sure what those temp nodes are affiliated with, so it might be worth asking the developers of Hwinfo over on their forums, as it's likely erroneous if all of the UEFI temperature readings are...

Hi,

The headers are standard PWM, so 12W.

Hello,

Set memory frequency and primary timings manually and set VSOC to 1.15v

IOD VDDG around 1.05v and CCD around 0.98v.

See if the issue persists.

Given these updates are currently tagged with a beta prefix, can only recommend those experiencing stability issues that weren't previously to revert back to an AGESA pre 1.1.9 and wait for official...

Many factors account for audible noise referenced as "coil whine". Certain combinations of power supplies and graphics cards will have a large impact on power-related noise, so it is not something...

https://m.majorgeeks.com/files/details/latencymon.html

Latency mon is designed to help you diagnose issues with real time data streams, such as the issues you're experiencing.

Hello,

Is there something specific you have seen that is making you feel under-supported not having an increased power limit? It would be good to show something tangible so that it shows this is...

Hello,

Run a DPC latency tester such as latency mon and see if anything is flagged.

Hello,

The board should likely POST fine, however, if a concern one can either pick a board with USB Flashback functionality, or ask a system integrator to flash the BIOS for them prior or after...

Hello,

Curve Optimiser is a feature specifically catered for Zen 3 architecture and does not support previous generations of the CPU.

Hello, Q-Code 8 indicates an issue with the CPU. Reset to optimised defaults. If the issue persists, reseat the CPU and cooler whilst checking for even mounting pressure.

Yes, GPUT III is still currently in Open Beta as observed.

Hello,

If wanting something that rivals the RIVBE The CH8 or the Dark Hero likely fit your MO for feature sets.

Hello,

That kit shouldn't be an issue. GSKILL hand binning is worth the investment if looking for best chance of compatibility as the there's normally plenty of guard band in place.

Hello,

Feel free to provide feedback on Discord.

https://discord.gg/gw5za739

I would remove the riser cable from the system to eliminate it entirely.

Hello,

Appreciate the wait is frustrating, but please keep these discussions to OCUK. Nobody here will be able to tell you where first tier distributors are sending cards as this is entirely down...

Hello, you are installing a GEN 4.0 card into a GEN 4.0 compliant motherboard, adding an additional layer for the user is counterintuitive. If one is installing a GEN 4.0 device, it's not much to...