Search:

When I first installed the board, there was a protective film on the front of the heatsink and a film on the back of the heatsink protecting the thermal pads. These should be peeled off.

Possible...

I've been running pretty stable with the following settings on my 3900XT C8HW setup.

Load default settings, go back into BIOS and find and try setting these entries:

AI Overclock Tuner: D.O.C.P...

I was running into USB detection issues with an error code 7-14 on my Crosshair VIII Hero on initial setup.

The only USB ports that seem to allow the headset to go through the Windows Mixed...

Same experience on my side. Went directly to EZFlash to flash, PC rebooted upon completion and then began updating the LED firmware. All my settings were reset and had to manually re-enter them in.
...

I noticed after performing a clean uninstall and install of these audio drivers packaged with DTSX Ultra/DTS SU Extension Driver - 1.1.69 that I no longer get the following two Software Components in...

What is Q-Code "9E"?

I noticed that when I set TPM in the BIOS to Firmware and generate new Secure Boot keys in the BIOS, my system always loads up Windows 10 with a Q-Code of: 9E

If I turn off...

With the computer off, have you tried pulling the CR2032 battery out of the motherboard for several minutes and then place it back in?

Normally, after pulling the battery or after performing a...

I am running a 3900XT. I wish I waited for the 5900X, but I think I would have lost sleep trying to get it. Getting a RTX 3090 was a struggle in itself.

Forgot to add, make sure you install the...

I have a similar issue as well on my VIII Hero (WIFI). On random occasions, whether the computer is sleeping or after shutting down for a few hours, I can't turn on the computer with either the...

I use to get the same idle reboots and WHEA errors in the event viewer with my setup as well. After going through forums, I found after setting the following, I stopped getting these issues.

After...