Search:

Ya fan noise can ruin the daily use of your PC, I have settled on Corsair Mag Lev fans myself, they run at less than 600rpm at idle and at full speed they create noise but it is the air being pushed...

No I had looked on HWBOT when I first got the board and seen everyone using 0506 so I immediately updated to that version, I have since installed the board in a case and set it up for daily use so...

Can you please list all your hardware specs and what you use your PC for. Memory overclocking can be tricky business and I personally am not the best at it. The gains are really very minor if...

What temps did you have with original fans? I am not familiar with the Noctua fans, are they designed for use on radiators? or as case fans

Is VCCIO and VCCSA in default auto mode? Try adding .25 volts to the dram voltage, it may just be your CPU IMC struggling, they are not all capable

My system would not boot with my memory kit using XMPI, but all is fine using XMPII.

If you continue with this issue please post all your hardware specs to make it easier to troubleshoot.

MRBULL, I was experiencing the same thing a while back on my X Apex, I tried disabling sound card, etc. with no luck, after a major Windows update I was able to install without any issues, I still do...

Dennis L, can you please list all of your components, and what load you are experiencing this buzz please. Have you checked the Nvidia forums for users with similar experience, even though the cards...

Unless I'm wrong the monitor may not complaint with required specs. I don't know if the Netflix app is complaint either, I thought you have to use Microsoft Edge for 4K

My Gene came with 0401, am running 0602, just got a 9900K yesterday, haven't done a lot of testing but it does run higher clocks on less voltage than the 9700K did, what were they high on when they...

I have been using Corsair 150i AIO, I connect the pump to a SATA power cable, pump speed monitoring cable to AIO header to monitor speed only, fans are connected to CPU fan header using a 1 to 3 fan...

Seyumi,
I imagine they make these decisions based on sales, and at this time on Intel's chip shortages, they can't supply enough PCH chipsets much less CPU's which is hurting motherboard sales so...

Leave it on

As HiVizMan says you will not have any problems

Very bottom of driver download page "Device QVL"

You should be able to push the top of the board against the back of the case to insert the screws, yes it is a tight fit but I have been able to install these boards in Corsair, Lian Li, NZXT cases

Enter bios press F5 for all default settings no XMP and test, if you have other bios settings saved along with XMP save to a profile in tools section of bios first then you can return to your saved...

Easiest way to find out is set F5 defaults in bios and see if it fix's your issue, report back with your findings

That is one way to do it :)

I think Intel has picked up on Nvidia's playbook and clocking there chips higher out of the box leaving less on the table to play with, can't blame them i guess

Glad to hear you are all set up and stable, Adaptive mode is the only way to go on a daily rig

Hopper64, yes sir it should, as long as nothing is in the second x16 slot or DIMM.2 card.

Yes that is a protective layer over the thermal pad

My guess is the OS was installed in legacy mode instead of UEFI, you may need to change boot settings in the bios, enable CSM, UEFI and Legacy boot

I have used Corsair AIO's for awhile, it is important not to use to much TIM and to carefully cross tighten the block but in my experience if mounted per instructions they cannot be over tightened....

I have never had any luck changing timings using this APP. Why it froze I cannot say for sure. There is a bios setting in the Apex bios to allow timing changes on the fly, have you tried changing...