Search:

Type: Posts; User: Nate152

Search: Search took 0.05 seconds.

  1. Well I never owned a z97 board but you could try...

    Well I never owned a z97 board but you could try raising the cpu system agent offset voltage +.335v and let the digital analog voltage on auto, without knowing what it's set to from the start I can't...
  2. All right That must be the cpu system agent...

    All right

    That must be the cpu system agent offset voltage, if it's running at .824v try an offset of +.335v, this should put the cpu system agent voltage at 1.15v - 1.16v.
  3. On average you'll need about .05v to hit the next...

    On average you'll need about .05v to hit the next 100MHz, give it a try and see if it stabilizes.

    Clintlgm - The 950 pro is an NVME drive.
  4. Hi jrmpt Try adding a little more cpu core...

    Hi jrmpt

    Try adding a little more cpu core voltage.
  5. Well I'd say you're doing pretty good so far,...

    Well I'd say you're doing pretty good so far, your cpu is 3.5GHz stock and boosts to 3.9GHz, to have it running at 4.5GHz with only 1.20v is quite amazing.

    There is a point where our cpu's will...
  6. Try letting the cache voltage on auto and see if...

    Try letting the cache voltage on auto and see if it's any better.

    You should try and squeeze out what you can from the cores as that will give you the most performance gain, overclocking the cache...
  7. Yes please give that a try, you may need a little...

    Yes please give that a try, you may need a little more cpu core voltage if the cpu is hanging.
  8. Hi jrmpt Yes you can run adaptive mode with...

    Hi jrmpt

    Yes you can run adaptive mode with Realbench, just change the cpu core voltage to adaptive and enter 1.270v in the "Additional Turbo Mode Cpu Core Voltage". Make sure speedstep and the...
  9. Well good to see you got it worked out Perko...

    Well good to see you got it worked out Perko and was an easy fix. It's nice you have a backup board too it sucks when your computer is down.
  10. Hey Perko ! Check in the bios and see if both...

    Hey Perko !

    Check in the bios and see if both cards are being recognized. On the extreme tweaker tab click GPU Dimm Post.

    If it's not showing in there double check your pcie cables.

    If it's...
Results 1 to 10 of 10