Search:

Type: Posts; User: pkincy

Page 2 of 2 1 2

Search: Search took 0.00 seconds; generated 50108 minute(s) ago.

  1. I solved the problem. I just broke off the tab....

    I solved the problem. I just broke off the tab. What a ridiculous piece of plastic.
  2. How to remove Graphics Card from Asus ROG Strix Z370-E

    As it says. There apparently is some locking mechanism on the end of the expansion slot that is covered by the graphics car that I can't get to. Anybody got any secrets.
  3. Replies
    7
    Views
    4,345

    I had a similar problem, however it was constant...

    I had a similar problem, however it was constant not intermittent. What had happened was that I was working in the bios and had inadvertently set the bios to work of the iGPU and didn't realize it. ...
  4. Most recommendations I have seen recommend not...

    Most recommendations I have seen recommend not using the Asus software suite at all as it causes more troubles than it helps.

    I did use it on my I7-2600k build but no longer use it on my I7-8700k...
  5. Thank you. I realized today that the USB-C port...

    Thank you. I realized today that the USB-C port is working. I hooked up a external spinner and it immediately recognized the drive. What didn't work was my USB-C cord to a SSD. Yet the SSD works...
  6. ROG Z370-E: Neither USB-C port on mobo works

    Have a new build with a Z370-E mobo. It has usb 3.1 gen 2 support on the mobo and the rear panel. I have a Fractal Define R6 case that has a USB-C connection to the mobo USB 3.1 Gen 2 header on the...
  7. Replies
    2
    Views
    690

    My CDM scores were essentially the same pre and...

    My CDM scores were essentially the same pre and post bios update. I am using a 1TB HP NVME M.2 SSD on my Z370-E.
  8. Yes. Either RAID 1 or RAID 2

    Yes. Either RAID 1 or RAID 2
  9. Replies
    0
    Views
    436

    ROG Z370-E: Jumper setting for cpu voltage

    At what point should the cpu overvoltage jumper be set to 2/3 to enable overvoltage?

    Would something as simply as using XMP require it to be enabled?
  10. Replies
    1
    Views
    381

    ROG Z370-E: New Build Memory Location?

    Manual says put dual channel in A2, B2 which is slots 1 and 3 counting from the right of the board towards the i/o panel. I couldn't get the stick in A2 to read. Moved them to A1, B1 and all seems...
  11. ROG Z370-E: Can I create a RAID 1 across both NVME slots at PCI bus speeds?

    As stated. Had Restore failures on my last build and want to use both M.2 slots with 960 GB NVME drives to set up a Raid 1. Will they both work at PCI speeds?

    Can I UEFI boot into both with a...
Results 26 to 36 of 36
Page 2 of 2 1 2