Search:

Type: Posts; User: booya

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. My MB is MAXIMUS X HERO. I understand correctly...

    My MB is MAXIMUS X HERO. I understand correctly that I can make the M.2 drive work as a simple PCIe, so that the OS detects it without any additional drivers? Even so, will it be significantly faster...
  2. Can I use the M.2 SSD under Windows 7 without any restrictions?

    Now I have several SSD drives with SATA interface, but I need one M.2, which will have 2 main partitions. The active partition will be bootable (the system will be restored to it). I don't want to...
  3. This is System Repair Disc from Windows 7. To...

    This is System Repair Disc from Windows 7. To restore the image of the system partition, I booted from it. But it always, even on previous platforms, copies very slowly if the controller operates in...
  4. I got what I wanted by switching SATA to Intel...

    I got what I wanted by switching SATA to Intel RST mode :rolleyes:
  5. MAXIMUS X HERO. Can't select IDE mode of the SATA controller.

    Previously, there was such an option, but after updating BIOS on 2203 it disappeared, now there is only AHCI and Intel RST. I have a boot disk that only works normally in IDE mode. I can boot, but...
  6. Replies
    8
    Views
    4,409

    You can change VRM Switching Frequency in DIGI+....

    You can change VRM Switching Frequency in DIGI+. Some users have written that this helps. My board also sometimes makes such sounds.
  7. Replies
    6
    Views
    5,666

    In order for the CPU to downclock, some of these...

    In order for the CPU to downclock, some of these options must be enabled: Intel SpeedStep, Turbo Mode, Intel Speed Shift and CPU C-States. I did not turn them off.


    My current OC (not tested yet,...
  8. Replies
    6
    Views
    5,666

    Do you use manual mode or adaptive/offset? Now I...

    Do you use manual mode or adaptive/offset? Now I have manual 1.215V + LLC 6 in BIOS and AIDA64 shows 1.216 at idle. The voltage stays the same under any load (heavy, like Prime95 and medium, like...
  9. Replies
    6
    Views
    5,666

    1ntel Thanks for the answer. I remember that...

    1ntel
    Thanks for the answer. I remember that Raja wrote, that LLC up to 5 level corresponds to the Intel specification. And overshoot can't be seen without an oscillograph. Here it is written that...
  10. Replies
    21
    Views
    5,888

    How did it end? No more restarts?

    How did it end? No more restarts?
  11. Replies
    6
    Views
    5,666

    X HERO + 8700K. Can I disable "Ring Down Bin"?

    Is it safe? I have manual voltages without offset:
    - vcore 1.2V
    - LLC 6
    - AVX 0
    - Cache 8-45
    - MCE disable
    - Sync All Cores with Ratio limit 45

    So now I have 800-4500 MHz with 1.2V at idle...
  12. The rest of the tools work fine. Acronis (Windows...

    The rest of the tools work fine. Acronis (Windows boot CD, not Linux), modern Norton Ghost, Paragon and of course Windows 7 System Repair Disc. Well, it's time to move on to something new. But it's...
  13. I tried to create an image using the Acronis boot...

    I tried to create an image using the Acronis boot disk (CD) - instead of 15 minutes, it will take several hours and I don't know what the final result will be. 10-20 seconds the program copies the...
  14. And what if during copying, the motherboard...

    And what if during copying, the motherboard thinks that the system stopped responding and rebooting? :confused:
  15. This version is from 2003. The boot flash drive...

    This version is from 2003. The boot flash drive was made more than 10 years ago, but when the OS is launched and even the program itself, the flash drive can be removed.

    I didnt use Ghost under...
  16. Yes, I knew this, but I resolved all or almost...

    Yes, I knew this, but I resolved all or almost all the problems (chipset, USB 3.0 and Windows Update).

    But what about MS DOS and Ghost? I noticed that if I just run this program, then the reboot...
  17. PC restarting under MS DOS (no kidding) when Norton Ghost is Running.

    MAXIMUS X HERO

    I ran into a strange problem. I booted from the USB flash drive and when creating an image (actually, it just copies the files) in this program, the computer restarts without...
  18. Sorry for being a little rude, but this is not...

    Sorry for being a little rude, but this is not right. In addition to the fact that modern motherboards look stupider, there may be a problem with the back panel.

    I solved my problem by riffler and...
  19. Same case, same MB and same problems. The...

    Same case, same MB and same problems. The faintly-looking plastic casing is removed.

    I didn't have such problems with Maximus IV Extreme-Z and Rampage IV Extreme, because they was ATX/eATX, but X...
  20. I really don't know any other software (3DMark...

    I really don't know any other software (3DMark etc., it's almost useless for this).

    I'm starting to think, that Max VCORE 1.35V it's absolute safe voltage and 1.4 (called Absolute max) it's......
  21. Using it from the Socket A times. Can't imagine...

    Using it from the Socket A times. Can't imagine another way to get a stable OC.

    But I ran P95 for a long period of time only a few times on this CPU. Last was more than a half year ago. The same...
  22. CPU degradation during the year? (within safe/semi-safe limits)

    3930K(C2) was new (BOX), water cooled, never worked (more than ~1 hr) at voltages higher than vcore 1.38V, vtt 1.1V, vccsa 1.15V (measured with a multimeter).

    PC running constantly (24/7), all...
  23. Hello! It was a PSU! As soon as I start 3DMark11...

    Hello! It was a PSU! As soon as I start 3DMark11 + P95 (Small FFT), power shuts off immediately with AX1200i. With Platimax 1500 it's OK and I can see that it consumes up to 1375 W from the wall. But...
  24. Could this be incorrect OC of my cards? I think @...

    Could this be incorrect OC of my cards? I think @ 1137 MHz I have no such problems. During 12 hrs under FC3 all was OK, then another "tests" for 2-3 hrs.




    I can say only one thing about RAM -...
  25. RIVE keeps on shutting off randomly under heavy load.

    Hello.

    In which cases the board can turn the power off and power it on again under Far Cry 3? I'm not playing, just leaving the computer for a few hours while camera is pointed to the place where...
Results 1 to 25 of 61
Page 1 of 3 1 2 3