Search:

Type: Posts; User: Cara Carcass

Search: Search took 0.01 seconds.

  1. Replies
    14
    Views
    4,072

    I tryed that now - not the problem. Old battery...

    I tryed that now - not the problem. Old battery came out with ok voltage.
    Put a brand new in just to be sure. Did not help. Thx for the suggestion though!
  2. Hey - now its the microphone jack that detects...

    Hey - now its the microphone jack that detects and loses a new microphone every 5 seconds.
    Cant even watch a series because the audio stops for the time the detection is running.

    10 5 seconds...
  3. New audio device detected every 5 seconds

    I hate this board with all my beeing.
    After i now can run ddr4 3200Mhz on 2 16Gb sticks, for which i have to flash the bios everytime i turned down the computer and disconnect the power chord, a new...
  4. Replies
    14
    Views
    4,072

    I tested this 4 times now. If i unplug the power...

    I tested this 4 times now.
    If i unplug the power chord for a brief moment, i cannot start my pc at all , with anythign higher than 2133 on the ram.

    After flashing the bios with the same 3008...
  5. Replies
    14
    Views
    4,072

    I have the same ram and i was full of joy, jusyt...

    I have the same ram and i was full of joy, jusyt you like you.
    SOC to 1.1V - DDR voltage to 1.4V - and just bopot the damn thing.
    It worked for 5 Days until i went and visited my parents over...
  6. Replies
    2,679
    Views
    1,715,674

    Thx for the reply

    I tryed on my second MB - the led stops blinking as is off when the update is finished. This board goes back.
    And no, i did not mention the renameing process since its obvious how it works. But i...
  7. Replies
    2,679
    Views
    1,715,674

    Did that several times

    1.)Read my whole post! This is a reply which tells me to do somethign which I already tryed several times.
    Only because I tryed it sveral times, i started to look into disk formats and usb2.0/3.0...
  8. Replies
    2,679
    Views
    1,715,674

    Thats how it was before

    Yes, thats how it was before when i updated to 1201 and 1403. But its not doing it anymore. I guess i have to send the board in. Something is horribly wrong.
  9. Replies
    2,679
    Views
    1,715,674

    Did that already

    I tryed that with USB 2.0 USB 3.0 Fat 32, NTFS and what not.
    I just tryed it again in case i somehow didnt test FAT 32. The bios Button blinks 3 Times and then stays on. I bet it will be on tomorrow...
  10. Replies
    2,679
    Views
    1,715,674

    No Boot Possible

    Hey,

    since I updated to 1403, I cannot boot anymore when I touch anything in the bios.

    In order to get my PC to boot into windows I have to:
    1.) Reset COMS by pushing that Button on the back...
Results 1 to 10 of 10