Search:

CSM-> Disable and see if the issue is still present. You most likely need to reinstall windows correctly with CSM disabled.

Flck 1800 & DDR4@3600 should be fine, if not, raise the SOC Voltage to max of 1.1v but 1.0v should work.

(1) Are you putting the kits in ram slots 2 & 4 from CPU.
(2) Do you have both power connectors above the CPU on the left hooked up.
(3) What are you using for cooling solution on the CPU and is it...

Run Intel Driver Assistant
https://www.intel.com/content/www/us/en/support/intel-driver-support-assistant.html

Eight months of 'ok' is really a good result, but I'm wondering if you maybe were not using DOCP profile and was loose & slow enough at default to just not be present.

The system, if set DOCP...

T-Group Ram, you mention, its config 4x16 (is that two kits of 2x16) with 'TF4D432G3600HC18JDC01' as that is 2x16 kit.

From what I read of your posts, you have a memory issue going on. Try using...

At a guess, you may have corrupted the installation of windows. You have near to top-of-line CPU and bottleneck for power being supplied to the motherboard.

Connect both E-ATX as recommended

Set DOCP profile for your RAM

Procedure for install of windows on a new NVMe drive.

Enter BIOS, Advanced mode,

1 - Make sure you unplug all SATA and USB...

I would try running the motherboard, in the motherboard box, but I also agree code 00 is CPU DOA unless standoff screw on board causing issue or overtightening of the heatsink.

Any chance overtighten cooling solution (cpu heatsink), back it off 1/4 turn on the screws.

Maybe try blowing away the Nvidia drivers with Display Driver Uninstaller (DDU) and reinstall the latest, does not appear like monitor issue to me.

Do you happen to have any codec packs installed,...

Computer management, storage, disk manager snap in, unmount the device.

You could also disable the device driver, but the above is a nice way.

What is the actual purpose ?

Try running the tests here https://www.eizo.be/monitor-test/

Misread the post. my bad, thanks.

The Omega is DDR4
Maximus (which version) ?

For Plex instead of using UPnP

https://forums.plex.tv/t/how-to-port-forward-asus-router/476336

Own two, 4800h 1660ti what do you want to know ?

There are no guarantees with RAM even when they match (unless bought as a x4 set), however from experience, keep the matched pairs together and then try rotating them around in the slots. You may...

Is the version number on them identical too ?

I've told you how to fix it.

Do you have it plugged in correctly?

The pump AIO_Pump Header (far right) and the fans should go to the CPU_Fan header (middle) and the other (left) CPU_Fan_Option.

Go into Advanced

Monitor -> QFan Configuration
AIO Pump Control Enabled.

off memory, ymmv.

In the BIOS, did you change it to AIO ?

Also, do you have the plug for the AIO plugged into CPU_FAN header

This is subjective at best.

Personally, I let the board monitor what matters and the novelty wears off once your system is a few years old and runs perfectly day in day out. That said, my go to AP...

Try https://www.asuswrt-merlin.net/ Merlin firmware, you can flash back to Asus firmware, no harm in trying. Been while since used it (moved off ASUS routers about three years ago), but it has better...