Search:

Type: Posts; User: 5150 Joker

Search: Search took 0.00 seconds.

  1. Did this with the new board with and without...

    Did this with the new board with and without Corsair link attached and there were no problems. So far it's holding up good so I packed up the first one and am going to send it back to Amazon later...
  2. Hey Raja, The system was already on 1001 bios...

    Hey Raja,

    The system was already on 1001 bios and I reflashed it prior to this happening and reset the cmos. Anyhow, at the time of the writing, there were no external USB devices connected. The...
  3. I'm going to run memtest tonight but I really...

    I'm going to run memtest tonight but I really doubt the ram is faulty. I ran the R5E cd that came with it and it installed all the drivers etc and nothing showed as missing in the device manager. In...
  4. Weird issues with Rampage V: USB refresh sound constantly + random shut downs

    Ok so the board was working good for a few days and then today it started having problems. The most concerning is that the system will shut down without warning (no bsod or error messages, event...
  5. Got it working finally. Had to take out the coin...

    Got it working finally. Had to take out the coin battery and let it sit. Thanks everyone.
  6. It's 2133 MHz memory rated at 1.5v. It can...

    It's 2133 MHz memory rated at 1.5v. It can easily handle 100 MHz bump. In the manual it lists no issues with changing bclk with xmp set, I think you should recheck your own info. Even...
  7. The bios I upgraded from was 1604. @Zk17 yes I'm...

    The bios I upgraded from was 1604. @Zk17 yes I'm aware it changes memory frequency but the ram can easily handle it. It should not switch back to 100 because BCLK recovery is disabled. When I get...
  8. No, should it even be needed?

    No, should it even be needed?
  9. Maximus V Formula: Can't change BCLK no matter what!

    Am I doing something wrong here? I set it to XMP and then change the BCLK and then save. In the bios it shows the change but as soon as I hit Windows, its back at 100 BCLK rather than what I set it...
  10. Replies
    25
    Views
    34,357

    I can't log in either...come on Asus!

    I can't log in either...come on Asus!
  11. Ditched Windows 8 and went back to Windows 7 with...

    Ditched Windows 8 and went back to Windows 7 with a fresh install and the world is right again with everything working like it should.
  12. Problem with AsMedia USB 3.0 controller - Maximus V Formula

    Hi everyone,

    I just recently got back into desktops after several years and chose Asus as the brand since i'd been using Asus boards prior to that for years. Well to cut to the chase, everything...
Results 1 to 12 of 12