Search:

Type: Posts; User: broncogr

Page 4 of 7 1 2 3 4 5 6 7

Search: Search took 0.72 seconds; generated 73298 minute(s) ago.

  1. Replies
    22
    Views
    11,140

    This is after shutdown, sleep is disabled and on...

    This is after shutdown, sleep is disabled and on Windows 8.1 x64 pro.
    Will do
  2. Replies
    22
    Views
    11,140

    My pc also has started turning on on its own. On...

    My pc also has started turning on on its own.
    On 0901, never happened on 0802 or previous.
    I will check this afternoon all the usb devices connected.
    Might have something to do with that...
  3. Replies
    10
    Views
    4,248

    The 12V rail is where it is been taken from.

    The 12V rail is where it is been taken from.
  4. Replies
    8
    Views
    3,787

    Check if your external USB drives have updated...

    Check if your external USB drives have updated firmware
  5. Usually it is USB devices that cause the issue

    Usually it is USB devices that cause the issue
  6. Replies
    3
    Views
    1,947

    You are welcome :)

    You are welcome :)
  7. Replies
    3
    Views
    1,947

    Look at the manual page 1-39. You can control 4...

    Look at the manual page 1-39.
    You can control 4 headers with 2 channels for each one.
    You control channel A of each of those headers and the settings are mirrored to channel B
  8. Replies
    3
    Views
    3,838

    You cant RAID them for them to be bootable. You...

    You cant RAID them for them to be bootable.
    You can raid them in Disk Management inside widows and use them as a data drive though.
  9. Enjoy your new system :)

    Enjoy your new system :)
  10. Usually this kind of behavior is attributed to a...

    Usually this kind of behavior is attributed to a usb hub or device.
  11. Did you try clearing CMOS from the button in the...

    Did you try clearing CMOS from the button in the rear?
  12. Thread: Pwm fans

    by broncogr
    Replies
    8
    Views
    4,386

    Are those fans corsair sp120s and more than 4 of...

    Are those fans corsair sp120s and more than 4 of them?
  13. Replies
    6
    Views
    3,325

    What fans are you using? Are the headers...

    What fans are you using?
    Are the headers correctly configured as PWM or Voltage regulated in UEFI?
  14. Try with CSM disabled in bios. My Asus 780GTX...

    Try with CSM disabled in bios.
    My Asus 780GTX gives priority to its HDMI port unless I do that.
  15. Thread: bad 5930k ?

    by broncogr
    Replies
    29
    Views
    13,789

    Check if the screws on the base of the EK Evo...

    Check if the screws on the base of the EK Evo protrude and hit the socket's mounting latch not allowing full contact with the IHS.
  16. Replies
    8
    Views
    4,597

    Have you installed the power button cable...

    Have you installed the power button cable correctly on the motherboard header?
    Try reversing it
    Unless you are using the power button on the board. If so see if you have installed the 24pin, 8pin...
  17. Replies
    5
    Views
    2,203

    If you are experiencing the issue as some users,...

    If you are experiencing the issue as some users, including me for some time, were facing with Raid getting corrupt, even setting defaults in Bios will trigger the issue and render your array useless....
  18. Replies
    17
    Views
    9,443

    http://www.kitguru.net/components/power-supplies/z...

    http://www.kitguru.net/components/power-supplies/zardon/corsair-hx1000i-platinum-modular-psu-review/2/

    Look at the cables included.
    You can either split the appropriate 4pin+4pin EPS/ATX12V...
  19. Replies
    17
    Views
    9,443

    I think that for the corsair h1000i you can split...

    I think that for the corsair h1000i you can split one of the 8 pins to 2 4 pins.
    I believe the 4 pin to be a requirement
  20. Never had any issue with leaving the arrays...

    Never had any issue with leaving the arrays connected to the controller while flashing new bios for many different builds until now.
    While I believe I have solved the issue, I will be prudent and...
  21. I also don't think the 0802 uefi changed...

    I also don't think the 0802 uefi changed anything.
    For me the repositioning of the drives on the controller seems to have solved the issue.
    You might want to check if for you everything works...
  22. Thank you for your efforts and support mate.

    Thank you for your efforts and support mate.
  23. Thread: Reboot Issue

    by broncogr
    Replies
    8
    Views
    4,746

    Bios 0801 isn't unofficial, its just isn't...

    Bios 0801 isn't unofficial, its just isn't updated yet in the motherboard support page
  24. I would backup the arrays and then update Bios...

    I would backup the arrays and then update Bios and try to find the issue by following above suggestions at this point in time.
    Better deal with it now rather than be caught unprepared and without a...
  25. Thread: Reboot Issue

    by broncogr
    Replies
    8
    Views
    4,746

    Try latest 0801 or 0802 bios.. Might be some...

    Try latest 0801 or 0802 bios..
    Might be some kind of instability
Results 76 to 100 of 164
Page 4 of 7 1 2 3 4 5 6 7