Search:

Type: Posts; User: Odaik

Page 2 of 2 1 2

Search: Search took 0.00 seconds; generated 140937 minute(s) ago.

  1. Replies
    16
    Views
    32,931

    OK, I've tried using CPU-Z too and it seems the...

    OK, I've tried using CPU-Z too and it seems the voltage sticks to 0.909V no matter the loading or LLC setting. I've noticed a lot of software does act like this when using manual mode for voltage as...
  2. Replies
    16
    Views
    32,931

    Thanks again for your help. The lack of change...

    Thanks again for your help.

    The lack of change in voltage behaviour I am referring to is actually during the load scenario (Intel Burn Test). Asus software reports the voltage as 0.912V maximum...
  3. Replies
    5
    Views
    18,330

    I have selected the High Performance power plan,...

    I have selected the High Performance power plan, but I've actually modified it to enable all power saving tech. 0% for minimum processor performance, LSPM enabled etc. I just use high performance to...
  4. Replies
    16
    Views
    32,931

    Thanks - so even with there being no change in...

    Thanks - so even with there being no change in core voltage behaviour regardless of setting level 1 or level 8 this is normal?

    I'm using the Asus software to monitor voltage by the way, can I rely...
  5. Replies
    5
    Views
    18,330

    Even with auto settings, I found that the...

    Even with auto settings, I found that the voltage/frequency remains fixed regardless of power state or loading.

    I did just try to use "offset mode" instead of "manual mode" for the voltage, and...
  6. Replies
    5
    Views
    18,330

    CPU cache not underclocking/undervolting

    Hello,

    I am using an Asus Gryphon Z87 motherboard with an Intel i5 4440 CPU.

    In the system BIOS, I have set the minimum and maximum CPU cache multipliers at x8 and x33 respectively - equal to...
  7. Replies
    16
    Views
    32,931

    On my board's BIOS there is an option for...

    On my board's BIOS there is an option for modifying the voltage across the CPU cache - I've also seen it referred to as the 'uncore' or 'ring bus' voltage. I'm assuming then that LLC has no impact at...
  8. Replies
    16
    Views
    32,931

    Can you confirm on which line the reduction of...

    Can you confirm on which line the reduction of vdroop actually takes place? Would it just be the vcore or would it also negate a drop in cache voltage, DRAM voltage etc?
  9. Replies
    16
    Views
    32,931

    Thanks for your response! Can you confirm to...

    Thanks for your response!

    Can you confirm to which voltages the LLC will apply? Is it only the vcore it will affect? The reason is all my stability testing so far has been with LLC on "auto", and...
  10. Replies
    16
    Views
    32,931

    Thanks for the continued assistance. My...

    Thanks for the continued assistance.

    My principle doubt about using "auto" settings on voltage parameters is that they tend to apply too much voltage. Whilst this is not a safety concern when not...
  11. Replies
    16
    Views
    32,931

    Many thanks for your response! I've had a look...

    Many thanks for your response!

    I've had a look at a lot of the stickies, and found that they mostly explain what each parameter does but does not explain what happens for each parameter when...
  12. Replies
    16
    Views
    32,931

    "Auto" or Fine-tune?

    Hello,

    I recently built a system around the Asus Gryphon Z87 and the i5 4440.

    There are dozens and dozens of settings on this board relating to power regulation, voltages etc and most were...
Results 26 to 37 of 37
Page 2 of 2 1 2