Search:

Overclocking is a lottery. That's why it's called overclocking. The QVL merely shows it may work. Not that it 100% will.

We don't tolerate expletives, sorry. I've issued a ban. Complaints are fine. Expletives will get you a warning, and then a ban. Aggression and threats only go so far, too.

For everyone else, if...

Might be due to the latest Windows patch. Have you tried rolling back?

It is tested at the frequency shown in the QVL. Pay attention to the disclaimers, though. Anything that can be classified as an overclock isn't guaranteed to work because variance comes into play.

No. Realtek held firm to it being caused by the NV driver.

MxFrgz and epicDoC, please keep expletives out of your posts. It is against the forum rules. Just because the swear filter catches them, does not mean it is okay.

Should be ok.

You can download those modules from an older version and the installer should let you tick the ones you want to install.
Which build version of Windows 10?

Be sure to fill out the feedback form please, guys. It is linked in the OP.

List out all relevant specs. Include Ai Suite version used, DIP module version, Windows build etc.

They know it affects everything.

In any case, that's what happens when the temp is breached, it overrides the delays.

I've pitched some stuff to Intel about AVX offset, but it takes up to five years for features like this to be changed. It's a long process. They are aware of some of the limitations.

No, it isn't. The situation manifests because of the CPU temp breaching the permissible max. When that happens, the fans are instantly ramped to 100% duty cycle/max speed. Changing that threshold or...

When we spoke to Intel about some of the AVX quirks, and there was one reply that stated a lot more applications use the code than people realize. Apparently, some Net Framework apps/utilities do,...

THe MCE option syncs all cores at the Turbo frequency when the processor goes into load state (assuming SpeedStep is enabled). It is an overclocked configuration, and there are some weak CPUs that...

That depends on clock jitter, I think. The better receivers have good clock circuits and employ DACs with good jitter rejection (Pioneer receivers measure well in that regard).

The market has evolved to using HDMI audio, and on gaming motherboards, focusing on stereo headsets driven with HRTF is the order of the day, so you wont see these legacy standards being employed...

The default should be 'best case' (when nothing else is changed), which requests the lowest VID. Not sure if the defaults have changed recently, but there may be some correlation to the some of the...

There are a few things you need to bare in mind:

1) The QVL does state the following:

-Memory module with memory frequency higher than 2133 MHz and its corresponding timing or the loaded XMP...

The rails are tied, so the cache ratio affects the requested VID. Intel changed the way Adaptive works for this gen. Not much we can do about it.

There should be a calibration option in the Aura software, would try that.

You can use splitters. The following conditions should be observed:

1) For chassis fan headers, the total power consumption should not exceed 12W per header (12V @ 1 Amp). Ideally, you want to...

Did you insert the CPU the wrong way? The tool helps, but does require correct alignment. That much is down to you. You dont have to use it. Whether you do or not, though, make sure you insert the...

It’s normal to hear some coil whine from inductors and some types of capacitor. How much can vary from system to system.

DIP 5 is a module of AI Suite. You can’t run DIP5 unless AI Suite is on the system, and, there can be a version co-dependency, so a DIP download can include both files.