Search:

That's stil a very capable system...the 3080 will deliver a bit more than those two cards can deliver on the one card...avoiding many dual card issues...where SLI does not work it will deliver more...

Hmmm...well I've seen a lot of probs with these kits...

You could try one stick at a time and see if one of them is dodgy....assuming they are OK...
You can try raising DRAM voltage..1.375 even...

Have you set XMP? (DOCP)

Maybe set DRAM voltage to 1.35 (or try 1.365) manually...set 1.1v SOC

These CPUs have a very robust IMC...3600 C18 at that density should be no problem from what I have seen..

Fan control is a breeze...

The chipset fan and VRM fans have never spun up on any of...

I would get a MXIIFormula and some 3600Mhz RAM with fast timings...like C14 stuff...

Yeah sounds like the best option will be to do a clean install on your new drive of W10 and then you'll have access to your other drive from there....

No credit needed.

If you are trying to transfer an OS I would just do it and see if it boots up...and then I'd do what you need to do hoping Windows can use what it has built in to cope...
...

No need to overthink this...

New system clean install...so just disconnect all but your target drive and internet...boot from install media...install OS...install drivers from MB...install GPU...

No...no need to follow any order...

You can save your profiles to USB as CMO files and transfer them between BIOSes these days...;)

4000 can be tricky if the CPU IMC is not up for it..

Try 1.45 Dram and 1.25 SA and IO...up to 1.3v

Try tweak modes too

You might find 3600 with tighter timings works better

Have you increased DRAM voltage?

Yes...MXIIHero...4000 18-18-18-38 1.45Dram 1.27 SA and IO single 32 GB kit...passes Karhu RamTest

Obviously this assumes the RAM is good and the IMC semi capable

86265

Maybe try the GPU in the second slot down...i.e. the second slot with the metal protector?

Do you have a spare PSU to try?

86259

Can you get into BIOS?

Clear CMOS

Maybe remove all power and remove MB battery for 30 min

Mixing kits even of "same" type is never going to help with high frequency RAM

My experience with these chips leaves me a bit nonplussed with the IMC...however 4000 I've got running on several
...

All the Qconnectors are the same...same pin-out on all MBs.

Here's a diagram...
86079

General rule of thumb...connect connectors with writing side down and they'll be right orientation +/-...

Exactly that....boot time has almost nothing to do with your drive specs.

It depends much more on platform...RAM density...training...driver initializations...windows fast startup setting...etc etc

Boot time is almost entirely unaffected by your boot drive...

Yeah...looks the same thing to me...should be fine

If you are careful, there should be no need to replace the thermal pad.

If something goes wrong......

If I were you I'd download a fresh copy of the previous BIOS...1401...use BIOS flashback method to flash that and not bother with later BIOS

Get something like a GT710

Try manual 1.36v LLC4

Adaptive uses VID and your offset will add voltage to an already high vid

Page 1-12 of the manual has all you need to know to make a decision...the info there is more pertinent to making a choice than temps....temps should not be an issue anywhere with adequate cooling
...