Search:

Praz · 03-22-2018, 03:13 PM

Duplicate thread.

Praz · 03-22-2018, 03:12 PM

Hello

If the ROG_EXT connector is is a priority one should choose the motherboard with that in mind.

Praz · 03-19-2018, 03:24 AM

Hrllo

This is the wrong section of the forum for this. Please repost in the correct section.

Praz · 03-12-2018, 03:40 PM

Hello

Not rubbish. What you have found is after 80+ views not a single person is going to waste their time replying to a post that contains absolutely no pertinent information.

Praz · 03-05-2018, 03:58 PM

Hello

For a given frequency AM4 will require more memory voltage than Intel. In simplistic terms think of the additional voltage as a method of strengthening the signal to make up for the...

Praz · 03-04-2018, 11:29 PM

Hello

Early on the 3600 C15 kits from G.Skill were the best that was available followed by the 3200 C14 kits. I have several sets of both and the 3600 kits will match any kit presently being sold...

Praz · 03-03-2018, 08:34 PM

Hello

This is the wrong section of the forum for this type of issue. Please open a thread in the forum section for your laptop.

Praz · 02-23-2018, 01:23 AM

Hello

The sticker is correct. XMP is for memory speeds greater than default speeds. 2400MHz is within the default speed range for the platform so is "plug n' play". No issue here.

Praz · 02-22-2018, 11:49 PM

Hello

You need memory rated for and programmed at a speed greater than default. There is no need for XMP settings with 2400MHz spec'd memory.

Praz · 02-08-2018, 12:07 AM

Hello

The info clearly states ports not headers. As such both the listed specifications and the manual are correct.

Praz · 02-05-2018, 01:15 AM

Hello

There has been nothing posted that substantiates this claim other than your conjecture. Thread closed and title edited to reflect your unfounded assumptions.

Praz · 02-04-2018, 12:19 AM

Hello

3400MHz memory speed plug n' play is being overly optimistic by several hundred MHz. If no tuning time if wanted stay at 2933MHz or lower.

Praz · 01-21-2018, 11:46 PM

Hello

Different platform/architecture.

Praz · 01-21-2018, 11:37 PM

Hello

Completely normal. The controllers need a double restart to fully initialize when booting after power has been removed.

Praz · 01-15-2018, 01:45 AM

Hello

The 4-way bridge requirement is because of slot spacing. If only using 2 videos cards in the x16/x16 slots use the bridge that fits that configuration and place the network card in the x8...

Praz · 01-15-2018, 01:34 AM

Hello

This is not an issue with ASUS. The operating system is what handles, confirms and places the downloads in the appropriate folders. It is the user's responsibility to know where the default...

Praz · 01-13-2018, 12:23 AM

Hello

Both the included and online manuals are very clear that PCIEX8_2 and PCIEX8_4 slots are non-functional when using a 28 lane processor. This is by design at the hardware level not a BIOS...

Praz · 01-10-2018, 04:15 AM

Use the existing thread everyone else is posting in.

Praz · 01-09-2018, 11:51 PM

Hello

Depending on settings double booting is normal. Some overclock settings require EC programming to be done in two steps.

Praz · 01-09-2018, 03:03 AM

Hello

Most devices installed on the motherboard as well as some low level drivers require a portion of physical memory for mapping. This has always been the case and as such is a non-issue.

Praz · 01-06-2018, 10:57 PM

Hello

Displeasure can be shown without swear words. Thread closed.

Praz · 01-04-2018, 12:06 AM

Hello

This is an issue concerning the processor not the motherboard. As such, regardless of the platform, there is absolutely no valid reason for motherboard RMAs. While you are relishing in the...

Praz · 12-30-2017, 08:01 PM

Hello

The explanation was given in post #3 of this thread.

Praz · 12-30-2017, 07:55 PM

Hello

Adaptive voltage mode works fine if the board is set up properly and one is not relying on inaccurate software reported voltage values.
...

Praz · 12-29-2017, 11:58 PM

Hello

A BIOS update cannot fix this. Intel does not support Optane compatibility for any AMD platform. Intel 200 series and newer chipsets are required.

Search:

Search: Search took 0.03 seconds; generated 61436 minute(s) ago.

Thread: Z370 and ROG_EXT (rog extension)

Thread: Z370 and ROG_EXT (rog extension)

Thread: BSOD Caused by ntoskrnl.exe

Thread: M.2 to PCi not working in slot 2_2?

Thread: Goodbye Intel hello AMD

Thread: Goodbye Intel hello AMD

Thread: Stuck at ROG logo while installing Windows Update

Thread: Where is the XMP option in Maximus IX Hero bios?

Thread: Where is the XMP option in Maximus IX Hero bios?

Thread: USB onboard R6e help needed.

Thread: 2nd Ryzen 7 1700X killed by my Crosshair VI Hero - Unfounded

Thread: How do you deal W these bugs? I've only worked with it for 2 days and already Fed UP

Thread: ASUS ROG X HERO cold start PC power on then shut down after 3 second then power on

Thread: ASUS ROG X HERO cold start PC power on then shut down after 3 second then power on

Thread: Rampage VI Extreme x16/x0/x16/x8

Thread: Can anyone tell me where Asus puts downloads of MB updates?

Thread: Rampage VI Apex Quad GPU Not Detected x8 Slots

Thread: Hey ASUS, Answer this for us all!!!!!!!!!!!!!!

Thread: Double post when setting ram to 3200 mhz & Ryzen overclocked by itself

Thread: X299 deluxe 64g memory only catch 63.7g in win10?

Thread: Bios updates for Spectre (CVE-2017-5753 & CVE-2017-5715)

Thread: SPECTRE and MELTDOWN: Bug rocks Intel / ARM CPUs

Thread: ROG STRIX Z370-I GAMING LLC-problems

Thread: Prime Z370-a / i7 8700k Overclocking guidance please

Thread: Intel Optane M.2 - BIOS NVME Raid Not Supported on 801 and 804