Search:

Type: Posts; User: NemesisChild

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. It is not good practice to combine unmatched sets...

    It is not good practice to combine unmatched sets of memory, even if it's the same brand and model.

    When it comes to system stability and peace of mine, always use matched sets.
  2. IBT basically stresses the CPU and not much else....

    IBT basically stresses the CPU and not much else.

    RB is more realistic in that it stresses the entire system: CPU, graphic card, and memory.
  3. Since you manually set the frequency, did you...

    Since you manually set the frequency, did you also enter the base timings and DRAM voltage?

    If you're not familiar or comfortable doing this, then try enabling the XMP profile.
  4. Who told you that? Depends on the component...

    Who told you that? Depends on the component quality and PC usage. PSU performance degrades over time.

    5 years is pushing it for most units let alone 10 years.
  5. 750w PSU should be plenty for your system. How...

    750w PSU should be plenty for your system. How old is the unit?
  6. If could be a hardware issue with the board. If...

    If could be a hardware issue with the board. If you bought it before Christmas then it should still be under warranty.

    I suggest contacting ASUS tech support, they may have you return it for a RGA...
  7. Did you try uninstalling the adapter in device...

    Did you try uninstalling the adapter in device manager and then reboot?
  8. I think you mean bios 0805. Did this also...

    I think you mean bios 0805.

    Did this also happen on previous bios versions? You may need to wait for a new bios version/update to see if it corrects the issue.

    However, there have been other...
  9. Replies
    16
    Views
    533

    Vcore = CPU voltage

    Vcore = CPU voltage
  10. Replies
    16
    Views
    533

    I don't use CB, so I can't comment on your score....

    I don't use CB, so I can't comment on your score.

    However, 89c is pushing the thermal limit. You do not want to go about 91c.
  11. You may have a short somewhere but I'm leaning...

    You may have a short somewhere but I'm leaning towards a GPU failure since you are getting graphical corruption.

    Here's what I would do, disconnect everything including all drives and USB devices...
  12. Have you looked at any software like HWMonitor to...

    Have you looked at any software like HWMonitor to see what is reports for DRAM voltage?

    We have seen this happen on a few boards where no matter what DRAM voltage is set in the bios, the actual...
  13. Your DRAM voltage looks low at 1.20v. Isn't that...

    Your DRAM voltage looks low at 1.20v. Isn't that a 1.35v set?
  14. Load all bios settings at default (including your...

    Load all bios settings at default (including your memory) and test stability.
  15. Thread: Run sli

    by NemesisChild
    Replies
    2
    Views
    194

    Yes, they are the same GPU. Keep in mind that in...

    Yes, they are the same GPU. Keep in mind that in SLI, both cards will run at the slowest speed of the two at default clocks.

    You can always overclock the non OC card to match the OC edition, but...
  16. Do you mean it happens after being unplugged from...

    Do you mean it happens after being unplugged from the wall?

    This is normal behavior whenever power is disconnected from the motherboard.
  17. Replies
    18
    Views
    995

    I can overclock my 3600 CL16 kit to 4000 just by...

    I can overclock my 3600 CL16 kit to 4000 just by raising the DRAM voltage. No other timing adjustments needed.

    And btw, it's a RGB set.
  18. Most PSU manufactures split the 8-pin CPU cable...

    Most PSU manufactures split the 8-pin CPU cable into a 4+4 pin connection because some non-enthusiast boards only have a 4-pin CPU port.

    As Menthol said, just use the 4+4 pin connector and you'll...
  19. Replies
    117
    Views
    25,518

    13.55v and you haven't fried your system? lol

    13.55v and you haven't fried your system? lol
  20. Replies
    1
    Views
    229

    Welcome to the forum! This is completely...

    Welcome to the forum!

    This is completely normal behavior after cutting off power to the mobo. It has to do mostly with memory training and not the bios version.

    If I recall, there should be an...
  21. Are you getting a failed overclock message on the...

    Are you getting a failed overclock message on the American Megatrends screen?
  22. Welcome to the forum! Do you have to do a hard...

    Welcome to the forum!

    Do you have to do a hard restart when the freezing occurs? Have you tried running with all bios setting at default?

    Also, failing or defective USB devices can cause...
  23. Anytime power is cut off from the board, the bios...

    Anytime power is cut off from the board, the bios goes through a series of memory training cycles/reboots.

    This is completely normal behavior.
  24. Replies
    6
    Views
    281

    Yes I'm having a close encounter with my mashed...

    Yes I'm having a close encounter with my mashed potatoes.
  25. Replies
    4
    Views
    930

    Why would bios 1704 be a last resort?

    Why would bios 1704 be a last resort?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4