Search:

Type: Posts; User: meankeys

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. You might want to check is thread out ...

    You might want to check is thread out

    https://rog.asus.com/forum/showthread.php?97577-Realbench-2-56-Luxmark-3-1-section-show-quot-OpenCL-ERROR-clCreateContext(-2)-quot
  2. Pleast post your system specs so we see what your...

    Pleast post your system specs so we see what your working with
    thanks
  3. Replies
    26
    Views
    3,539

    Are your water lines on the rad on top or bottom...

    Are your water lines on the rad on top or bottom - If positioned on top you may have air in the loop causing the higher temps.
    Just a thought
  4. Replies
    3
    Views
    557

    I havnt played with it much but make sure the...

    I havnt played with it much but make sure the bios settings are not conflicting with the Aura. Spray list your bios settings for him.
  5. Replies
    514
    Views
    295,232

    Sticky: Thanks Menthol I tested last night and it worked...

    Thanks Menthol
    I tested last night and it worked fine :) -- Your right not as much as a bump in score like earlier versions. Also win 7 use to yield higher scores. not any more. This version of RB...
  6. Replies
    514
    Views
    295,232

    Sticky: Thanks DooRules I haven't tried with that...

    Thanks DooRules

    I haven't tried with that version yet. all earlier version would crash OpenCL on me.
  7. Replies
    13
    Views
    2,600

    Very Nice!

    Very Nice!
  8. Replies
    514
    Views
    295,232

    Sticky: Sorry should have asked this in the first post -...

    Sorry should have asked this in the first post - Did you use the latest driver - 16.1.2 or something
    thanks
  9. Replies
    514
    Views
    295,232

    Sticky: Nice runs guy's Mentol were you able to run...

    Nice runs guy's

    Mentol were you able to run that with the openCL driver installed?
  10. I like it Arne - You do have a way with words

    I like it Arne - You do have a way with words
  11. Thank You

    Thank You
  12. Is this for all i9 series 7900X - 7980XE

    Is this for all i9 series 7900X - 7980XE
  13. LLCX add voltage under loads so if you rolled...

    LLCX add voltage under loads so if you rolled back to 4.8mhz roll back the LLC until you become unstable then bump it up a notch. you don't need the extra voltage if your not pushing it.
  14. Replies
    120
    Views
    13,792

    Thanks now I am hungry :) As far as the Bot...

    Thanks now I am hungry :)

    As far as the Bot goes - I am currently competing in Division I, II, III and Pro overclock 2018 - not doing to bad
  15. Replies
    120
    Views
    13,792

    Nice guide Arne.... Good to read you man

    Nice guide Arne.... Good to read you man
  16. Replies
    3
    Views
    760

    I would pull the cooler air in and push the hot...

    I would pull the cooler air in and push the hot air out. those temps dont seem that bad.
  17. Replies
    10
    Views
    2,053

    I have been using this HWINFO 64 get the latest...

    I have been using this HWINFO 64 get the latest version here. covers temps and voltage and then some

    https://www.hwinfo.com/download.php

    I would try to keep your temps 35-40c 24/7 - 50-60c ok...
  18. Thread: Maximus Tweak

    by meankeys
    Replies
    6
    Views
    5,270

    Yes - I believe it's in the timing setting at the...

    Yes - I believe it's in the timing setting at the top of the page
  19. Replies
    10
    Views
    2,053

    According to your system spec's you should have...

    According to your system spec's you should have decent cooling. Just keep an eye on your temps. What are you using to monitor your voltage and temps?
  20. Replies
    10
    Views
    2,053

    Go to page 3-12 in your manual - it shows you a...

    Go to page 3-12 in your manual - it shows you a picture - at the top it reads - CPU CORE RATIO - set to SYN ALL CORES that will allow you to set the ratio to what ever you want - a line just under...
  21. Replies
    4
    Views
    1,381

    you can try and re tim and seat the cpu. other...

    you can try and re tim and seat the cpu. other than that your temps seem about right on air. whats your voltage - and you said your on stock setting right
  22. Replies
    514
    Views
    295,232

    Sticky: ok - Let us know how you make out

    ok - Let us know how you make out
  23. Replies
    514
    Views
    295,232

    Sticky: Try running it from your download folder or...

    Try running it from your download folder or desktop with default setting no OC - is this a fresh install of windows 10

    thanks
  24. Replies
    514
    Views
    295,232

    Sticky: What is it doing or not doing? were are you...

    What is it doing or not doing?

    were are you running it from - download folder desktop etc.
  25. read this thread ...

    read this thread

    https://rog.asus.com/forum/showthread.php?97577-Realbench-2-56-Luxmark-3-1-section-show-quot-OpenCL-ERROR-clCreateContext(-2)-quot
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4