Search:

Type: Posts; User: Konig

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    247

    Rampage VI Extreme OMEGA Storage Options

    Hello all I recently builded a new PC and I had some questions regards the Storage options.

    I currently have a 280GB Intel 900p in the U.2 Slot as boot drive and one 2TB Samsung 970 plus in the...
  2. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Update to my situation. I delided my 7700k and my...

    Update to my situation. I delided my 7700k and my load temp went down by like 40c that realy funny, dialed in a 5.2ghz oc 1.42v and I get max load temps of 78c before even stock 4.5 ghz would hit...
  3. Replies
    3
    Views
    1,766

    Not much because on formula ix page they don't...

    Not much because on formula ix page they don't tell you much about the specs of the onboard. So far I found out that Strix raid dlx does 24bit 192Khz while formula ix does 32bit 192Khz not sure if...
  4. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    The two bottom fans are pushing air up to the gpu...

    The two bottom fans are pushing air up to the gpu because my PSU is insolated in another compartment on the other side of the case and increasing RPMs of fans that's kinda bad idea considering I'm...
  5. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Ya I noticed side panel front glass is quite hot...

    Ya I noticed side panel front glass is quite hot to touch but that don't make sense cuz I got 16x fans in my case. I don't think side fan is a problem because the side fan is intake just like the...
  6. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Using an air conditioner in my room I managed to...

    Using an air conditioner in my room I managed to reduced ambient temps down to 20c but my Motherboard temps are still like 50c on load with my PCB being 70c, cpu have not changed still same temps.
    ...
  7. Replies
    3
    Views
    1,766

    Strix raid dlx VS formula IX

    Hi everyone I wanted to know if any one knows the diferences between strix raid dlx sound card and formula ix onboard audio, I wanted to know all the diferences and if formula ix onboard is same or...
  8. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    My motherboard temps idle is like 27c and PCH is...

    My motherboard temps idle is like 27c and PCH is 49c and during load motherboard gets up to like 40c and PCB 65max.

    I had same temps with my 6700k that blew up, when I first got this cooler my...
  9. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    @nate152 the rad can't be placed in front because...

    @nate152 the rad can't be placed in front because the tubes is to short, my game temps are average 60 with spikes up to 89c at times so idk it's not right I guess my cooler is going bad I had it a...
  10. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Small room with loads of other tech, Funny part...

    Small room with loads of other tech, Funny part is its winter in sweden -10 outside xD summer ambient temps are like 35-40c for me
  11. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Posted a pic of my case layout, All my fans are...

    Posted a pic of my case layout, All my fans are Corsair 140mm MLF 2400RPM fans and my two radiator fans are NOctua Industrial 3000RPM black fans
  12. Replies
    25
    Views
    4,291

    I did not like adaptive voltage and those stuff...

    I did not like adaptive voltage and those stuff for some reasone it made my pc more unstable at higher volt than needed and for some reasone cpu would not boost to its full ghz in some stuff like...
  13. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    I use same paste thermal grissly as you and I put...

    I use same paste thermal grissly as you and I put a small dot in the middle then just slam the water block ontop and screwed until I can screw any more.


    Load temps
    Realbench max 70-75c 32gb ram...
  14. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    I have 30c ambient temps in my room not sure if...

    I have 30c ambient temps in my room not sure if that may be reasone of high temps*
  15. Replies
    25
    Views
    4,291

    Ain't the constant voltage changes and ghz...

    Ain't the constant voltage changes and ghz changes bad for the cpu ?*
  16. Replies
    25
    Views
    4,291

    I've set it but I still run max voltage and max...

    I've set it but I still run max voltage and max ghz*


    Also for all others out there DISABLING SVID support removes adaptive voltage option *
  17. Replies
    25
    Views
    4,291

    It could be my settings something is maybe...

    It could be my settings something is maybe disabling this option*


    As I tough something where disabling the option found it now *
  18. Replies
    25
    Views
    4,291

    Got the latest one, only have a option called...

    Got the latest one, only have a option called offset*
  19. Replies
    25
    Views
    4,291

    Weird because I don't have this option. And...

    Weird because I don't have this option. And Telstar I know Ghz gain more but my cooler can barely sustain stock 7700k and ram speed don't affect cpu temps a lot*
  20. Replies
    25
    Views
    4,291

    Can you guide me trough how to get adaptive...

    Can you guide me trough how to get adaptive voltage to work I seem never to got that to work before and also would adaptive voltage not mean the cpu can draw as much voltage as it would want*

    ...
  21. Thread: Error 00

    by Konig
    Replies
    58
    Views
    14,998

    Could be the age of the cooler maybe*

    Could be the age of the cooler maybe*
  22. Replies
    25
    Views
    4,291

    Just to update I set my ram voltage to 1.5v and...

    Just to update I set my ram voltage to 1.5v and the system would boot in 3000mhz but ain't 1.5v a lot**
  23. Replies
    25
    Views
    4,291

    Ya paste and mount his good I use therma grizzly....

    Ya paste and mount his good I use therma grizzly. *About system agent and VICCIO ain't it to high ? Sould I lower it I tried 1.16750 and seems to work fine.


    Realbench stress test pass but when I...
  24. Replies
    25
    Views
    4,291

    Temps are bit on the high side even with a realy...

    Temps are bit on the high side even with a realy low 1.23 load volt*

    Prime95 max temp 85c with AVX using no AVX downgrade
    Realbench 70-75c ish. Is this not high for a H110i Gtx in pushpull...
  25. Replies
    25
    Views
    4,291

    How does all my other settings look ? Is it all...

    How does all my other settings look ? Is it all under the safe limit ?

    Funny in aida64 Extreme I get hardware failure test stoped when I try to do stress test but realbench passes 10h and prime95...
Results 1 to 25 of 68
Page 1 of 3 1 2 3