Search:

Type: Posts; User: AdamC

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. I have had this same b1 problem since I got this...

    I have had this same b1 problem since I got this mb. It happened once in a while. Drain the power then start up always fix this problem. No you don't need to clear the CMOS. Just drain the power off...
  2. Replies
    41
    Views
    10,652

    Have you ever unplugged the power and completely...

    Have you ever unplugged the power and completely drained the remaining?
  3. Replies
    8
    Views
    2,723

    Some older versions of GeForce driver will cause...

    Some older versions of GeForce driver will cause realbench to crash when stopped.
  4. Replies
    33
    Views
    10,352

    I actually suspect the problematic usb device is...

    I actually suspect the problematic usb device is the front display.
  5. Replies
    33
    Views
    10,352

    I tried raising the voltage to 1.40v and 1.35v...

    I tried raising the voltage to 1.40v and 1.35v eventual and up the speed to 3000MHz. All good for a few days and then this morning code 61 again.

    Updated the BIOS to 1902 which I don't think it...
  6. Replies
    25
    Views
    10,358

    Blah, after a few minutes BSOD. Guess we need a...

    Blah, after a few minutes BSOD. Guess we need a custom water cool to run this.
  7. Replies
    25
    Views
    10,358

    Oh my, tried OCCT the first time and it reported...

    Oh my, tried OCCT the first time and it reported cpu was over 85C and it stopped while front display only showed 7xC. I raised the program setting to 90C. Ran it again and it stopped again.
  8. Replies
    8
    Views
    3,136

    I did swap the wires so the bios always showed on...

    I did swap the wires so the bios always showed on my center, but then Nvidia likes to use the right monitor as default.
  9. Replies
    8
    Views
    3,136

    Somehow every time after I enable surround view...

    Somehow every time after I enable surround view and then go back to normal view, Nvidia will lose the my default monitor setting. I will have to set it again.
  10. Replies
    23
    Views
    7,368

    I tried and it was unstable. It would hang...

    I tried and it was unstable. It would hang immediately in game. The factory spec is 3000 15-16-16-35-2 1.35v. I was able to run it at 3000 before but ended up more often with "cold-boot-unplug ".
  11. Replies
    23
    Views
    7,368

    Didn't know this OCCT will stress CPU more than...

    Didn't know this OCCT will stress CPU more than realbench or prim.
  12. Replies
    23
    Views
    7,368

    My air cooler NH D15 does a better job than your...

    My air cooler NH D15 does a better job than your AIO water cooler. I have never seen above 80C, not even upper 70's in stress test with below settings.

    44x100 core adaptive +0.250v System Agent...
  13. Replies
    33
    Views
    10,352

    I use default auto on DRAM, which I believe it...

    I use default auto on DRAM, which I believe it is 1.2V. The dilemma of this x99 and DDR4 as far as I read is 'drift'. My system overall is stable. Only sometime in the morning the first time I will...
  14. Replies
    33
    Views
    10,352

    I have played with memory voltage before. The...

    I have played with memory voltage before. The challenge is not always more is better. And adding voltage to DRAM will affect other areas.

    I also think GSkill exaggerate their memory performance....
  15. Replies
    33
    Views
    10,352

    You are not alone. I have this same problem since...

    You are not alone. I have this same problem since day 1 and it has been over a year by now. It only happens during the first boot in the morning and it does not always happen. When it does I have to...
  16. 1450/8000 is also the ceiling of my MSI Gaming....

    1450/8000 is also the ceiling of my MSI Gaming. Oddly if I increase the power and temperature limit in Afterburner, it actually will be less stable.
  17. Basic Fire Strike is more CPU. Last I tried 3 way...

    Basic Fire Strike is more CPU. Last I tried 3 way 980Ti I only got 24xxx. Those 980Ti's were overheated and throttled back. With two 980Ti's I constantly get around 23xxx. Yeah in my case 3 way...
  18. Replies
    39
    Views
    13,642

    Have this board for a year and since day one...

    Have this board for a year and since day one sometime fresh in the morning I will need to pull the plug, drain the remaining power before it can boot.
  19. Cool, thanks for the info. Yes I am a Premiere...

    Cool, thanks for the info. Yes I am a Premiere member and I do shop a lot from them. In my state Amazon charge sale tax where Newegg don't. :)

    I was just curious how triple 4k surround view would...
  20. Bought a 3rd 980Ti and I found 3-way is much...

    Bought a 3rd 980Ti and I found 3-way is much worst than 2-way in my case.

    1. First problem is power. While my 1200W PSU can handle 3 cards, the UPS is beeping becasue of overload.
    2. Getting...
  21. Replies
    12
    Views
    3,053

    There is a thread somewhere someone already spent...

    There is a thread somewhere someone already spent the time to compare ram speed at different frequency and timing. In some cases tight timing actually have better performance over higher frequency.
  22. Replies
    32
    Views
    12,846

    Advanced->APM Configuration --Power On By...

    Advanced->APM Configuration
    --Power On By PCI-E/PCI
    --Power On By RTC
  23. Replies
    32
    Views
    12,846

    Make sure you disable or uncheck both in BIOS and...

    Make sure you disable or uncheck both in BIOS and in Windows. There is a thread and many of us had this problem.
  24. Replies
    7
    Views
    3,174

    It works on me as well. So far I have yet...

    It works on me as well. So far I have yet encountered another boot problem.
  25. Replies
    20
    Views
    10,402

    I put a duct tap in between the cooler and the...

    I put a duct tap in between the cooler and the gpu. So far so good.

    48580
Results 1 to 25 of 138
Page 1 of 6 1 2 3 4