Search:

Hi,

The headers are standard PWM, so 12W.

Hello,

Set memory frequency and primary timings manually and set VSOC to 1.15v

IOD VDDG around 1.05v and CCD around 0.98v.

See if the issue persists.

Given these updates are currently tagged with a beta prefix, can only recommend those experiencing stability issues that weren't previously to revert back to an AGESA pre 1.1.9 and wait for official...

Many factors account for audible noise referenced as "coil whine". Certain combinations of power supplies and graphics cards will have a large impact on power-related noise, so it is not something...

https://m.majorgeeks.com/files/details/latencymon.html

Latency mon is designed to help you diagnose issues with real time data streams, such as the issues you're experiencing.

Hello,

Is there something specific you have seen that is making you feel under-supported not having an increased power limit? It would be good to show something tangible so that it shows this is...

Hello,

Run a DPC latency tester such as latency mon and see if anything is flagged.

Hello,

The board should likely POST fine, however, if a concern one can either pick a board with USB Flashback functionality, or ask a system integrator to flash the BIOS for them prior or after...

Hello,

Curve Optimiser is a feature specifically catered for Zen 3 architecture and does not support previous generations of the CPU.

Hello, Q-Code 8 indicates an issue with the CPU. Reset to optimised defaults. If the issue persists, reseat the CPU and cooler whilst checking for even mounting pressure.

Yes, GPUT III is still currently in Open Beta as observed.

Hello,

If wanting something that rivals the RIVBE The CH8 or the Dark Hero likely fit your MO for feature sets.

Hello,

That kit shouldn't be an issue. GSKILL hand binning is worth the investment if looking for best chance of compatibility as the there's normally plenty of guard band in place.

Hello,

Feel free to provide feedback on Discord.

https://discord.gg/gw5za739

I would remove the riser cable from the system to eliminate it entirely.

Hello,

Appreciate the wait is frustrating, but please keep these discussions to OCUK. Nobody here will be able to tell you where first tier distributors are sending cards as this is entirely down...

Hello, you are installing a GEN 4.0 card into a GEN 4.0 compliant motherboard, adding an additional layer for the user is counterintuitive. If one is installing a GEN 4.0 device, it's not much to...

Hello,

Most riser cables are not GEN 4.0 compatible. You will need to either find one that is, or connect the card directly to the PCIE slot. You can test this by enabling GEN 3.0 in the UEFI for...

Hello,

Try

VSOC up to 1.18v. IOD VDDG around 1 to 1.05 and CCD around 0.98 to 1.05.

You can also try increasing VDIMM to 1.38-1.1.4v

Hello,

Can you confirm if you're using a riser cable?

Thread moved to relevant section.

Hello,

Are the black screens in sync with those readings?

What is the system doing when the system loses signal?

Can you check in GPU Tweak? I would first assume it was a polling error. Try...

Can you confirm what resolution/refresh rate the panels are connected to the card, and also the power draw at idle?

87467

As previously stated AMD does not officially support X370 for 5000 series CPUs, even the chart you have provided confirms this. Coming here and showing experiemental builds from vendors and past...

Hello,

Could you point to me where in that article it states the chipset is supported by AMD with Zen 3 processors?