Search:

Hello,

Can you confirm if you're using a riser cable?

Thread moved to relevant section.

Hello,

Are the black screens in sync with those readings?

What is the system doing when the system loses signal?

Can you check in GPU Tweak? I would first assume it was a polling error. Try...

Can you confirm what resolution/refresh rate the panels are connected to the card, and also the power draw at idle?

87467

As previously stated AMD does not officially support X370 for 5000 series CPUs, even the chart you have provided confirms this. Coming here and showing experiemental builds from vendors and past...

Hello,

Could you point to me where in that article it states the chipset is supported by AMD with Zen 3 processors?

The board is entering safe mode due to failing memory training.

4 sticks at that density can be tough depending on the strength of the fabric on the CPU sample.

Try SOC @ 1.1 to 1.15v

IOD...

Hello,

Zen 3 support on X370 is not supported by AMD. There are no current plans to make Zen 3 available on ASUS X370 motherboards.

Hello,

The UEFI is not overiding them, it's simply how it's being interpreted depending on how and where the voltage is being read from.

You can safely volt these rails up to 1.3 so set a value...

Hello, I would suggest you take that up with them as other retailers have cleared their back log.

Supply is being stripped due to demand. The TUF was one of the hottest selling tech products on...

There are no plans for a higher power limit BIOS but this may be subject to change.

If the system is for work and stability needs to be unconditional then overclocking FCLK and the memory bus this much likely isn't the scenario you should be chasing, either.

Sounds like you may be trying to reapply an OC profile from a previous build. Although cross-build profiles are now compatible, using them across AGESA versions may not be. Be sure to try reapplying...

4x16GB with 3600 1:1 FCLK might be hard for some CPU to obtain without considerable SOC voltage. Depends on the CPU, but it's achievable. Be sure to test properly with Kahru RAM Test or HCI Memtest...

It's best to use UEFI to control fan headers for minimal overhead. Should be apparent when entering the BIOS.

Hello, you want to set a manual SOC voltage. Try between 1.05 and 1.15v. For four modules of 16, you will likely require the higher side.

You may also need to adjust IOD VDDG and CCD. Try...

These are fairly bold claims...

I haven't seen the behavior you are seeing on the 570-E and I have two to hand. Temperatures land in the 60c region...

See the below review, also similar...

Hello,

Remove memory overclocking by disabling DOCP/ XMP and leave the system at optimised defaults to see if the issue persists.

It is important to note that, even with improvements over last gen, not all 5000 series CPUs will reach 1900FCLK unconditionally. You can try adjust VSOC to around 1.15v and try VDDG around 1 to 1.05...

Hello,

Have you checked the power consumption of the card?

These can be found in Computer Management Under Windows Logs > System.

Hello,

Reachbench makes use of X256 encoding which uses AVX2, these extensions are known for pulling more current than conventional stress test routines. In regards to clocks and temperature, you...

Hi folks,

The table below shows which UEFI build you will need for AGESA 1180.

These will become available via the support pages over the next 48 hours.


87157

I'm currently using Firefox and am not experiencing this issue. Please disable any adblockers as this can play havoc with some capcha codes

Hello,

A further VBIOS update will be coming to address the fan threshold. Expect it to drop on the support pages within an ETA of a month's time.