Search:

Type: Posts; User: Saltgrass

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    30
    Views
    502

    Did you ever find out what device the following...

    Did you ever find out what device the following MAC address was associated with?

    B2:6A:16:B5:B6:E1

    This may be associated with the failed to connect address using UPnP

    192.168.50.90
  2. Replies
    30
    Views
    502

    It isn't important as to which Radio it is...

    It isn't important as to which Radio it is connecting, but the device that is connecting. If it shows as your iPad when these errors occur, take that device offline to see if it helps.

    If you...
  3. OK, beside the fact I don't even know what WAN...

    OK, beside the fact I don't even know what WAN LAG is, the AX11000 has a 2.5 GB gaming and a 1 GB WAN port. The AXE11000 has both of those ports showing as WAN, the AX11000 does not.. I do see...
  4. Replies
    30
    Views
    502

    Ok, I give up..

    Ok, I give up..
  5. Update to post noted..

    Update to post noted..
  6. Replies
    30
    Views
    502

    You won't have that MAC address. You will use...

    You won't have that MAC address. You will use the one you show in your system log for eth7 and compare it to the clients listing on the Router..
  7. Replies
    30
    Views
    502

    OK, I hope it helps but just in case it doesn't...

    OK, I hope it helps but just in case it doesn't check this..

    eth7: Auth 0C:7A:XX:XX:90:8E, status: Successful (0), rssi:0

    87959
  8. Replies
    1
    Views
    88

    I was hoping someone that knew something about...

    I was hoping someone that knew something about this would reply but these forums aren't very busy.

    You might put the following command in a run box and check the graph produced. Maybe it would...
  9. Replies
    1
    Views
    183

    I suppose the first question is are you using a...

    I suppose the first question is are you using a Gateway for the ISP and if so are you bypassing the built-in router components?

    Since AX is the wireless component, do you get normal speeds with...
  10. Replies
    30
    Views
    502

    If the lights were to be involved, do you use...

    If the lights were to be involved, do you use voice control with them? I assume a smart phone is involved with controlling them..?

    You seem to be avoiding the question as to what eth7 is.. ;) ...
  11. Replies
    30
    Views
    502

    This is the MAC address you are looking for. It...

    This is the MAC address you are looking for. It does not show up in your network map Clients? Make sure and check both wired and wireless.. It looks like it authorizes this device and deauthorizes...
  12. I was going to mention something else in addition...

    I was going to mention something else in addition to the Reinstall. I believe your board uses an Intel 9560 Wi-Fi card. If so, it relies on some chipset/processor components to make it work, so...
  13. First, in case you did not know, there is a Z390...

    First, in case you did not know, there is a Z390 forum which may have more info.

    In my system, I have never used the Bluetooth network since it does not connect to Bluetooth devices such as...
  14. NewEgg has had the Hero XIII on back ordered for...

    NewEgg has had the Hero XIII on back ordered for a couple of weeks now. There are sellers on that site selling it for $700 to almost $1000.

    I believe once the 11th Gen processor is available and...
  15. Replies
    30
    Views
    502

    The eth7 is a device on your network. Look at...

    The eth7 is a device on your network. Look at your system log for a line like below and take the MAC address to the Network map. See if you can match up the MAC address with a device on your...
  16. Replies
    30
    Views
    502

    Did you ever find out what eth7 was? Do you...

    Did you ever find out what eth7 was?

    Do you run AIMesh with those other routers?

    Sorry you are sending it back before a more critical look at your log was taken.
  17. I don't have that board so I don't know how it...

    I don't have that board so I don't know how it was delivered but the plastic cover on the logo is probably just to protect the logo. There are usually a few of those type covers.. I would remove it...
  18. The WBM should be the primary boot device. If...

    The WBM should be the primary boot device.

    If I want to boot to something else, I use the Boot Device menu that boots that device just the one time so I don't have to change the Bios boot order..
  19. I will look at your information later but just to...

    I will look at your information later but just to start, you have an EFI System partition on the Corsair drive. Does you boot options show a Windows Boot Manager?

    Active partitions are used on...
  20. Replies
    13
    Views
    838

    @JeffLo, it would be nice if you could start...

    @JeffLo, it would be nice if you could start your own thread. Then we could discuss your situation. Such things as what is eth7 and why does it show 11min 2sec between cycles?

    Maybe when you...
  21. Replies
    13
    Views
    838

    I just wandered over to the Insiders site and it...

    I just wandered over to the Insiders site and it seems 21H1 will be delivered the same way 20H2 was delivered, through the normal updating process. I did not see any mention of Wi-Fi 6e in the...
  22. I was just wondering, does the cable that came...

    I was just wondering, does the cable that came with the dock have any special markings to designate it capabilities like Thunderbolt cables have? Any color differences on the different cables?
  23. Replies
    21
    Views
    440

    One thing I remember about Optical output which I...

    One thing I remember about Optical output which I use on other devices is sometimes the connects don't make correctly so make sure the cable is plugged in so it locks in place.

    I suppose you have...
  24. I added something to my post and the comments...

    I added something to my post and the comments about your specs were not meant for you.

    Maybe the fact that last M.2 slot supports SATA means it has connections for a PCIe 4 drive.
  25. I was just wondering if you are using Optane...

    I was just wondering if you are using Optane memory?

    Maybe it has to do with where those M.2 slots are connected to the system. There are some on the chipset and some on the processor..
    ...
Results 1 to 25 of 187
Page 1 of 8 1 2 3 4