Search:

Type: Posts; User: DragDay7

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Thread: POST failing

    by DragDay7
    Replies
    28
    Views
    784

    Here's your issue. You're running 4 ram sticks on...

    Here's your issue. You're running 4 ram sticks on XMP profile that is meant to be used with 2 sticks only. Of course you can get away with it and it does run fine sometime but you're not supposed to....
  2. Replies
    25
    Views
    1,340

    Read my post again. Have you tried to run...

    Read my post again. Have you tried to run TestMem5 few times? Does it throw error during any test?
  3. Replies
    3
    Views
    258

    Hi, Have you tried recovery with CrashFree?...

    Hi,

    Have you tried recovery with CrashFree? User manual, page 64.
  4. Replies
    25
    Views
    1,340

    Yea, I've spoke with people who managed to fix...

    Yea, I've spoke with people who managed to fix their freezing by changing motherboard with another brand. I've seen their vcore higher than mine. Still, I guess Asus techs are squeezing all they can...
  5. Replies
    25
    Views
    1,340

    Hi trihy, I've replied to your post at...

    Hi trihy,

    I've replied to your post at overclock forum, but I guess you must've missed it. I've talked to Intel - there is no extreme low voltage. According to Alders Lake datasheet (1st pdf, page...
  6. Replies
    25
    Views
    1,340

    https://i.imgur.com/T8eQP3g.png

    https://i.imgur.com/T8eQP3g.png
  7. Replies
    25
    Views
    1,340

    I'm watching your threads guys. I think I'm aware...

    I'm watching your threads guys. I think I'm aware of 6 cases of freezing PC on Z690-A Prime now - I get messages via discord and reddit about them from time to time.

    I could workaround this issue...
  8. I don't have much of a knowledge on RAM. Can you...

    I don't have much of a knowledge on RAM. Can you also disable fast boot in bios and try? How about setting XMP and lowering ddr frequency until it boots?
  9. How about running both sticks separately with...

    How about running both sticks separately with XMP? Does it work?
  10. I remember that pain. I used to backup everything...

    I remember that pain. I used to backup everything before wiping PC. It always took me a day to get it up and running. Now I'm trying to keep my OS and drive as clean as possible. Reinstalling...
  11. I think after is the way to go. You're clearing...

    I think after is the way to go. You're clearing stuff that's left behind. And yea, I'd bet CPU drivers will be there, but you got me curious - let me know. I uninstall hidden devices from time to...
  12. I would just swap them at once, run DDU. In...

    I would just swap them at once, run DDU. In device manager see hidden devices and uninstall old cpu if it's there. Just for my sake. \_(ツ)_/
  13. Replies
    2
    Views
    225

    Hey, I'm confused, why not?

    Hey,

    I'm confused, why not?
  14. Replies
    6
    Views
    624

    Have you disabled fast boot via power management...

    Have you disabled fast boot via power management in Windows control panel?
  15. Replies
    3
    Views
    428

    Those drivers?...

    Those drivers? https://dlcdnets.asus.com/pub/ASUS/LCD%20Monitors/ASUS_XG27WQ_WHQL_Driver.zip
  16. Replies
    11
    Views
    690

    But there is nothing special behind EPS cable -...

    But there is nothing special behind EPS cable - all pins are just +12v and a ground. It's all about how much load can it take. If 4 pin cable is rated for 105W and his CPU requires 90W the most then...
  17. Replies
    11
    Views
    690

    If 8 pin is enough to handle 190W CPU (12700), 4...

    If 8 pin is enough to handle 190W CPU (12700), 4 pin should be enough to run 95W CPU, right? Actually 4 pins are rated to handle up to 105W. Yours require 65W and peaks up to 90W.

    I say it should...
  18. If you want to get rid of 1-2 core boost disable...

    If you want to get rid of 1-2 core boost disable Thermal Velocity Boost (TVB) in AI Tweaker.
  19. Replies
    86
    Views
    5,691

    You guys have opposite issue of mine - I'm having...

    You guys have opposite issue of mine - I'm having z690-a prime board and my PC freezes once in a while unless I set adaptive voltage instead auto xD I'll try setting negative offset and see if it...
  20. Replies
    2
    Views
    282

    Hello, In your case PCIE will fallback...

    Hello,

    In your case PCIE will fallback automatically to 4th gen speed and it will work alright.
  21. Unless QFAN doesn't detect lowest fan speed like...

    Unless QFAN doesn't detect lowest fan speed like in my case. I have 4 DC fans with lowest speed at 28%. QFAN detects it at 28-33%, I've never been able to get 28% in all of them. Thus I just use Fan...
  22. I'm not that sure, if that'd be the case you...

    I'm not that sure, if that'd be the case you wouldn't be the only one with that issue.

    Have you tried clearing CMOS by unplugging power cord and shorting CLRTC pins? They're at the bottom of your...
  23. Does bios fan monitor shows rpm correctly or it's...

    Does bios fan monitor shows rpm correctly or it's reversed too?

    I thought maybe PWM signal is inverted but since in DC mode it behaves the same way, also any software controls fan just fine that's...
  24. What's your bios version? Also your cooler has...

    What's your bios version?

    Also your cooler has PWM fan and you should leave its mode like that.
  25. Replies
    7
    Views
    1,039

    Doesn't hurt to try. Also your specs doesn't...

    Doesn't hurt to try. Also your specs doesn't mention the second M2 drive. M2_1 goes directly to CPU just as the PCIe 5.0 that you're having issue with. I'm just wonder if your components are in...
Results 1 to 25 of 73
Page 1 of 3 1 2 3