Search:

Type: Posts; User: bscool

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds.

  1. https://youtu.be/7cQ-LF6V8lw?t=510 At 8:30...

    https://youtu.be/7cQ-LF6V8lw?t=510

    At 8:30 memory controller/dram freq ratio, that is for gear 1 and gear 2.
  2. As far as I know all 4 dim z690 are Daisy chain.

    As far as I know all 4 dim z690 are Daisy chain.
  3. If you are using a2 and b2 test each slot and...

    If you are using a2 and b2 test each slot and memory stick 1 at a time to rule out bad/weak slot or memory module.

    The little I have messed with gear 2 on z690 d4 it doesnt work very well. Better...
  4. z690 Strix d4 Edit sorry I thought this was...

    z690 Strix d4

    Edit sorry I thought this was for the Strix, noticed OP was asking about Tuf.

    Unless you have a KS I would stay on 901 if you are running DR b die(2x16) and are into memory OC. I...
  5. I have noticed RGB lighting on I can hear much...

    I have noticed RGB lighting on I can hear much more noise/whine verse disabled/off on most MB. Not saying it is the lighting just something I have noticed.
  6. 901 is best for DR b die. Bios ffter 901 you will...

    901 is best for DR b die. Bios ffter 901 you will need to set vddq manually to 1.35 to 1.4v to boot in the 4000+ range.

    The only reason I would run newer bios than 901 is if on KS you need it as...
  7. If you have tried all of that and it is still...

    If you have tried all of that and it is still having issues you can either lower clocks until stable or return. Pretty unlikely any bios update is going to fix it.

    I have 2 Apex 1 will run 6400...
  8. Replies
    134
    Views
    15,595

    Post has been deleted but can be found on other...

    Post has been deleted but can be found on other sites.
  9. Hmm I have 2 12900kf cpus that i have used in...

    Hmm I have 2 12900kf cpus that i have used in z690 Strix d4 and z690 Apex and they work.

    I have has that issues at times in Strix d4 where it stays on white led and monitor screen is black. What I...
  10. Hmm I have 2 12900kf cpus that i have used in...

    Hmm I have 2 12900kf cpus that i have used in z690 Strix d4 and z690 Apex. I have has that issues at times in Strix d4 where it stays on white led. What I did to solve was turn off psu. Then hold...
  11. Thread: 12900ks

    by bscool
    Replies
    11
    Views
    1,540

    https://www.newegg.com/intel-core-i9-12900ks-core-...

    https://www.newegg.com/intel-core-i9-12900ks-core-i9-12th-gen/p/N82E16819118392?Item=N82E16819118392

    I have seen some benches from a couple people and so far from what I have seen if you have a...
  12. Replies
    9
    Views
    1,476

    No different than updating. Use Ez Flash in bios...

    No different than updating. Use Ez Flash in bios or Flashback and you can go back to older bios.
  13. You are not suppose to use old CMO files on new...

    You are not suppose to use old CMO files on new bioses. This has been a best practice forever as far as I know. It usually works using old cmo files but it can cause issues and is nothing new.
  14. Sticky: @safedisk...

    @safedisk posted new bios 1304


    ASUS ROG MAXIMUS Z690 APEX | APEX 14

    ROG MAXIMUS Z690/STRIX Z690 Series Beta Bios 1304

    01. Improve system performance

    ROG MAXIMUS Z690 HERO BETA BIOS 1304
  15. I have never had that happen with a bios update...

    I have never had that happen with a bios update but I have had to reactivatee when switching MB or hardware. I used the phone activation to get it activated again.

    I used the method were they send...
  16. Replies
    17
    Views
    2,639

    On Apex and 1302 is good for me.

    On Apex and 1302 is good for me.
  17. Replies
    134
    Views
    15,595

    If you have an Apex and slot 1/chA clocks(is...

    If you have an Apex and slot 1/chA clocks(is stable) say 400 to 600mhz lower it is the MB most likely. Been confirmed by many. I have old board and new 2022 manufacture date and new board is night...
  18. Replies
    5
    Views
    812

    As far as I know 16gb ddr5 dims are SR. You...

    As far as I know 16gb ddr5 dims are SR.

    You can look at memtweakit on the last page at the RTLs and there will only be 1 for each channel if single rank.

    Edit i was thinking of DDR4 for the...
  19. Replies
    134
    Views
    15,595

    Have you tried 1 stick at a time. I see quite a...

    Have you tried 1 stick at a time. I see quite a few reports or slot b/2 clocking higher. I would try that to see if dim 2 is stable at say 6000 or 6200 and then test what slot 1 can do. If so there...
  20. Replies
    81
    Views
    7,018

    Hmm try removing the power strip from the system...

    Hmm try removing the power strip from the system or at the least plug the pc directly into the wall to eliminate it as a variable. That is what I would do anyway. You can leave your peripherals...
  21. Replies
    81
    Views
    7,018

    What did they do to test it? What programs did...

    What did they do to test it? What programs did they use or how did they test it or didnt tell you?

    With 12th gen I have seen it can pass all kinds of different stability, memtests and bench test...
  22. Replies
    134
    Views
    15,595

    If the memory doesnt have more than 1 xmp profile...

    If the memory doesnt have more than 1 xmp profile it wont show. Has nothing to do with MB it is memory kit and vendor specific.

    I posted link to screenshots with kits that show multiple profile on...
  23. Replies
    9
    Views
    1,941

    The XMP 3.0 profiles are up to the memory vendor ...

    The XMP 3.0 profiles are up to the memory vendor as far as I know. I see users on Asus with certain vendors show more than 1 profile
    ...
  24. Just use manual v core in bios. Leave turbo boost...

    Just use manual v core in bios. Leave turbo boost on.

    I dont quite understand what you want to do but if you want fixed/static vcore that is what you do.

    Note if using Sync all cache will stay...
  25. Replies
    81
    Views
    7,018

    Using the defaults bios settings is an OC on the...

    Using the defaults bios settings is an OC on the CPU, by default it set MCE to enabled. Set MCE to disabled and then it might run prime95 as it will follow Intel specs.

    Also run hwinfo64 while...
Results 1 to 25 of 174
Page 1 of 7 1 2 3 4