©ASUSTEK COMPUTER INC. ALL RIGHTS RESERVED.

omegasama · ‎04-11-2018

Hi guys

I just purchase a monoblock from EK for my rog r5e10 and due to that i had to remove the mobo and install the monoblock.

Once finished with the installation and re-sitting every component back in place, SSD/RAM/GPUs and upon booting am reading 1 error code on the qcode led " bd ". My overclock is gone and i cannot overclock again. I had my o.c saved and when i tried to apply it , guess what its not booting... error bd again.. so i update my bios(was 1503 if am not wrong) to the latest and tries to manually apply the overclock with the same exact settings i was using but still nothing...

I was hitting 4.5 stable with 1.31v and now i cannot event hit 4.0 or anything else, only stock. Seems like all the overclock am trying to apply is not working. I cannot boot my system when i try to overclock.

I reset the cmos, by removing the battery and also tried the cmos button at the back of the motherboard but nothing seems to be working now. I will provide proof of my benchmark if required.

Regards

Setup:

OS: W10
CPU: Intel Core i7-6850K
GPU:2x Evga gtx 1080FTW
MB: ASUS Rampage V Edition 10
Solid State: Samsung 950 PRO
PSU: Seasonic Platinum 1000w
Case: Corsair 900D
RAM :TridentZ 8x8gb ( F4-3200C16Q2-64GTZKW \ CL16-18-18-38 1.35v \ PC4-25600)

CPU+MoBo+GPUs are watercooled

UltraNEO_ · ‎04-11-2018

What happens when you remove your water-block and return to whatever method you used before?
If the error goes away, it could be something is shorting or your CPU isn't sitting right.

omegasama · ‎04-11-2018

For that, i will have to drain the system again . TBH am quite lazy right now. I notice also that i have only 48GB of ram out of the 64GB.. I tried 1 by 1 to make sure i do not have any faulty ram , i believe 1 socket is dead or something.

regards

UltraNEO_ · ‎04-11-2018

omegasama wrote:
For that, i will have to drain the system again . TBH am quite lazy right now. I notice also that i have only 48GB of ram out of the 64GB.. I tried 1 by 1 to make sure i do not have any faulty ram , i believe 1 socket is dead or something.

regards

Hopefully it's not a dead socket.. and what you are using is a fully Quad channel set of memory, DDR4 for some reason is a bit temperamental when it comes to installing. Unmatched modules can cause all sorts of problems.

[R5E10] Error code BD