I keep getting this error message "Access violation at address 045BB5A2 in module 'dip4.dll'. Read of address 00000000.' everytime I try and open Fan Xpert 4. I have uninstalled and reinstalled AI Suite 3 a few times now and I even did a fresh install of windows. That worked for a short time only to get the same error message later. I am using a maximus formula X, an asus 1080ti on a custom loop, a dd5 pwm pump plugged into chassis_fan2 because pwm is not supported on the w_pump+ header, and 4 rad fans plugged in chassis_fan3. I am trying to set the pump and fan speed to work off of water temp (which I had done successfully until getting this error). I only have live dash, aura sync, and AI Suite installed. GPU TWEEK 2 is not installed. Running Windows 10 pro Please help!