03-28-2019 11:50 AM - last edited on 03-06-2024 07:30 PM by ROGBot
03-28-2019 12:58 PM
03-28-2019 02:16 PM
Arne Saknussemm wrote:
Hey Iquit040
Actually I gave up on SLI just before I bought this platform, so I never ran it on the Zenith Extreme...
Are you on the latest BIOS? Have you tried changing RAM Distributed/Local mode (not sure if that would help just an idea)
Have you got the EZ plug populated (molex bottom of board)
You sure it's GPU related not RAM? I kind of guess so if SLI works on 1/2 but not 1/3
03-28-2019 07:51 PM
03-29-2019 06:10 AM
Cory29 wrote:
Personally I could get very few games to run in 4 way sli - and have less issues with 2 way but still run into stuttering and crashing too ...
this is on both amd and intel platforms support kind of fell out with developers when nvidia limited sli to only 2 cards
I can render on all 4 like a beast though (daily I only have 1 card in my system because of the random issues)
not saying there isn't a problem but you have to do allot of research and testing to figure out if its the board or the game or the cards
04-19-2019 03:48 AM
08-16-2019 09:03 PM
11-02-2019 08:50 PM
iquit040 wrote:
I have an issue with performance when running SLI in the asus suggestion configuration (slots 1 and 3). Games will have random stutters and sometimes crash the game, and other times completely lock the system up. When i disable SLI completely, the issue goes away. I looked up the Die access to the different PCI slots, slot 1 and slot 3 are on different Die’s and I am assuming this is the cause of the problem. My original build was a 1950x and 2x 1080ti and the issues were occurring then as well. Since then I have swapped out the Zenith Extreme motherboard for a new one, changed out the processor to the 2990wx, memory 8 new modules, and installed 4 new 1080ti different mfg / model. I am noticing though when SLI is using the suggested slots though, Same problem. I am wondering if anyone else has ran into SLI issues on the Zenith Extreme (besides the 2x 2080ti issue i had seen).
For the record: slot 1 and 2 SLI actually runs perfectly and scales appropriately. Has anyone else seen any issues SLI across the dies using slots 1 and 3?
(in the situations I am talking about I have disabled the other cards using the switches on the motherboard so I am only using 2 cards not all 4, and I tried using different SLI bridges as well)