- last edited on by
ROGBot
I just upgraded my SSD RAID-0 Previously I had (4 Intel 320 Series 120GB SATAII - All plugged into the 4 black SATAII Ports on the Rampage IV Extreme.)
I now have 2 Samsung 830 Series 256GB SATA3 SSD's in RAID-0 - Both plugged into the 2 Red Intel SATA3 Slots on the Rampage IV Extreme...
At first I tried to clone from the Intel RAID-0 To my Samsung RAID-0... and to make a long story short.. it didnt work. I spent over 6 hours trying to make it work! I finally got it to clone from RAID to RAID.. but then I couldnt get the SAMSUNG RAID-0 to boot!
So i ended up doing a clean install...
I was worried that I was wasting money on the 2 Samsung drives because 2 drives might saturate the intel raid controller! And i really wasnt able to find a post online about someone trying the 2 Samsung drives on the Intel C600 Onboard RAID Controller...
I am very impressed with my RAID-0 SATA3 Speeds!
Before i post a picture of the benchmark... Note that with the Intel 320 Series RAID-0 (4 SSD's) I was getting about 750MB/s SEQUENTIAL READ and about 550MB/s SEQUENTIAL WRITE
Anyone else have a RAID-0 SATA3 Setup? What are your speeds?
I now have 2 Samsung 830 Series 256GB SATA3 SSD's in RAID-0 - Both plugged into the 2 Red Intel SATA3 Slots on the Rampage IV Extreme...
At first I tried to clone from the Intel RAID-0 To my Samsung RAID-0... and to make a long story short.. it didnt work. I spent over 6 hours trying to make it work! I finally got it to clone from RAID to RAID.. but then I couldnt get the SAMSUNG RAID-0 to boot!
So i ended up doing a clean install...
I was worried that I was wasting money on the 2 Samsung drives because 2 drives might saturate the intel raid controller! And i really wasnt able to find a post online about someone trying the 2 Samsung drives on the Intel C600 Onboard RAID Controller...
I am very impressed with my RAID-0 SATA3 Speeds!
Before i post a picture of the benchmark... Note that with the Intel 320 Series RAID-0 (4 SSD's) I was getting about 750MB/s SEQUENTIAL READ and about 550MB/s SEQUENTIAL WRITE
Anyone else have a RAID-0 SATA3 Setup? What are your speeds?
LiveOrDie wrote:
BOLTS4BREKFAST test using Anvil's Storage Utilities then i can see what speeds your getting vs my ssds in raid.
I've never ran that utility before.. so i just left all stock settings and hit "RUN"
I have two Intel 520's. Same settings, of course as you turn up the % of non compressible data, score on a sf drive will go down. But these 520's are holding up real well. Been in R0 for almost 4 weeks now.
DooRules wrote:
I have two Intel 520's. Same settings, of course as you turn up the % of non compressible data, score on a sf drive will go down. But these 520's are holding up real well. Been in R0 for almost 4 weeks now.
You're not using the Intel RST Enterprise drivers? I notice your driver says "iastor" the enterprise driver is "iastorA"
DooRules wrote:
That is correct. The E driver is just too slow for me so I tried the 11 series and a major bump in bench's. 😄
On another matter at some point does the need to type in the image verification go away?
What drivers are you using and were did you get them from? BOLTS4BREKFAST
your score looks fine to me here what i get but remember im using SATA III
