07-31-2019 01:11 PM - last edited on 03-05-2024 08:03 PM by ROGBot
07-31-2019 02:12 PM
07-31-2019 06:08 PM
08-01-2019 02:25 AM
08-01-2019 06:38 AM
machproo wrote:
* Hello I just finished building a PC equipped with a ROG Dominus Extreme and a W3175X. No problems encountered apart with the contacts between the processeur and thé processeur support on the motherboard. The large number of pins in the LGA 3647 processor support requires a strong pressure in its support via the cooling block. The 4 screws should be tightened in the indicated order and thoroughly, especially the two middle screws in the center of the two long support sides, tightening them until the spring blades comes in contact with the cooling block. If the pressure applied to the processor is not sufficient, not all the pins in the processeur support make contact with the processor and the card does not start. You can check the consumption of the card and processor by connecting the USB socket of the Corsair 1600I power to another PC on which Corsairlink software is installed. You have to read a consumption of 250 watts or more if the processor runs.
Best Regards*
Machproo *
08-01-2019 01:39 PM
08-02-2019 08:11 AM
08-02-2019 09:30 AM
08-02-2019 01:25 PM
08-02-2019 01:46 PM
machproo wrote:
Hello,*It seems that you are a victim of the cold-boot bug during post which is bypassed by the Plug LN2 in position enable. See page 1-15 of the manual