My VROC array is in the "rebuilding" state and I'm wondering how long it will take since there's no progress percentage displayed and I've waited over 2 days.
It's 4x Optane 905p 380GB drives in RAID10. I noticed that one of the four drives had become unrecognized so I attempted to remove it. I removed drive 1 (accidentally as I was looking for drive 4) and then put it back. In doing so, I'm wondering if I somehow destroyed the array because at one point there was two drives missing which is more than the fault tolerance of one can handle. But I didn't boot an operating system during this time, only the BIOS, so there shouldn't have been any writes to the disk.
Now there's three drives connected and the array status shows as rebuilding. Viewing the details of each drive in the BIOS it shows that the status of the first two are "RAID Member", the third is "RAID Member (Rebuilding)", and a fourth isn't listed (because it's dead).
I tried rebooting into Windows but the Windows loading screen is shown for more than 24 hours. Should I continue to wait at the BIOS screen where it says rebuilding? How do I know that it's actually making progress in rebuilding?