Results 1 to 1 of 1
  1. #1
    New ROGer Array
    Join Date
    Sep 2019
    Reputation
    10
    Posts
    2

    Issue with gaming monitor and Zenith extreme

    First things first, my specs are:

    Asus ROG Zenith Extreme
    AMD Threadripper 2920x
    32GB G.Skill F4-3200C14Q-32GTZRX
    2x Asus 1080ti Poseidon
    Corsair AX1200i

    My main monitor is an Acer Predator XB1 27" WQHD IPS with 165 Hz and nvidia G-Sync (XB271HU)

    I have a secondary Full-HD monitor which is a cheap iiyama IPS that works fine.

    Before I upgraded my system to the aforementioned one, I used to have an asus X99 E-WS with an i7 5930k and 32GB of Kingston memory, same set of GPUs and screens. Everything was working perfectly fine.

    Now I have a VERY odd issue where if I plug in my gaming monitor (the Acer Predator) into my GPU (no matter which of the two or which DP port), I can't switch on my PC. It just flicks on for a split second and turns off. No boot attempt, nothing. It's as if overcurrent protection is triggered. After unplugging the monitor and turning on the PC, it boots a few times, but gets into windows just fine.
    It gets weirder: When I now plug in the monitor while the PC is running, everything is just fine, the monitor gets recognised and works! Unless I shut down the PC and try to turn it on again, then I have to unplug the DP cable from the GPU for the PC to turn on. Restarting the system on the other hand works with the monitor plugged in.

    I've tried the monitor on another PC and it doesn't have this issue, only on this system.
    I also plugged in the EZ-Plug on the Zenith Extreme MB, just for good measurement.

    Any ideas what the issue could be?
    Last edited by Dazley; 09-24-2019 at 10:55 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •