02-29-2012 07:50 PM
02-29-2012 09:23 PM
03-01-2012 01:29 AM
03-01-2012 02:10 AM
03-01-2012 02:20 AM
03-01-2012 02:40 AM
8 Pack wrote:
High LLC does put alot of current through that area as does the especially at 1.4v Vcore if the PC is heavily loaded. Was you actively cooling the VRM's as it says in the overclocking guide when using these settings.
Gr3chie wrote:
wow man that sucks, are you going to get this covered under warranty?
03-01-2012 03:29 AM
03-01-2012 03:42 AM
03-01-2012 03:49 PM
Shamino wrote:
its more than 50% likely bad contact of psu connector with MB pins.
loose connection, rust on the connectors, you have bad contact, you have smaller surface area to transfer high amount of current. resistance and heat becomes a vicious cycle, hotter , higher resistance = hotter = higher resistance, finally that.