11-13-2019 11:41 PM - last edited 3 weeks ago by ROGBot
11-14-2019 03:07 AM
11-17-2019 04:26 AM
Arne Saknussemm wrote:
Have you tried a different PSU?
I'd also reflash BIOS...BIOS flashback method...and check motherboard battery
11-17-2019 07:37 AM
Some tips from xkm1948
1. Dont run auto voltage on vcore, VCCIO, VCCSA, Vcache and VDRAM
2. Don't use XMP. Always set everything manually
3. Vcore wont hurt much. It is usually cache overclocking that kills your chip.
Keep your cache as close to 1V as possible
4. VCCSA is the same thing. Keep it as close to 1V as possible.
5. Provide adequate cooling for the VRM if you are using AIO.
vccsa 1.1
cache 1.0
vccio 1.05
11-20-2019 07:21 AM
ThrashZone wrote:
Hi,
Auto voltages usually kill 2011-v3 on asus boards and or chips.
Especially increasing memory from default 2133 and or using xmp profiles
Broadwell-e bios is why
It cranks vccio cpu way over anything haswell-e bios ever did which is pretty much it's standard voltage 1.05v
Broadwell-e bios shoots it up to 1.2v+ way more than needed even for a broadwell-e cpu
Plenty of reported cases with dead chips and asus boards only common denominator is auto voltages and xmp profiles being used.
Most bad things happen at startup on auto voltages.
11-20-2019 07:41 AM
11-20-2019 07:58 AM
ThrashZone wrote:
Hi,
I'm still on x99 sabertooth 2101 bios but it was released way back 1-06-16 which is the last bios before broadwell-e compatibility was added so I don't know which board you have
But full manual mode like I said should work on any bios.
VCCSA is an offset if you go full manual mode then you can enter 1.1v....
1.15v is a much better limit for system agent and vccio cpu/ pch.