- last edited on by
ROGBot
Anyone run into an issue with a GPU not clicking/seating deep enough into the PCIE slot?
Take note of the left edge of, above the SupremeFX Armor
I was thinking of getting a dremel and grinding a notch in the SupremeFX Armor so that my GPU can fit.
I didnt take the motherboard out of my case yet, so cant check the back side to see if there are any screws holding it in place.
If there are screws, im just going to take the armor off and cut a slot instead.
GPU is a EVGA 1080 Hydrocopper. I was thinking of getting a 2080 TI FTW3 Hydrcopper so that it can fit, but I really want to get the 3080 Ti this year.
Take note of the left edge of, above the SupremeFX Armor
I was thinking of getting a dremel and grinding a notch in the SupremeFX Armor so that my GPU can fit.
I didnt take the motherboard out of my case yet, so cant check the back side to see if there are any screws holding it in place.
If there are screws, im just going to take the armor off and cut a slot instead.
GPU is a EVGA 1080 Hydrocopper. I was thinking of getting a 2080 TI FTW3 Hydrcopper so that it can fit, but I really want to get the 3080 Ti this year.
Can ignore thread, didnt realize the rubber cable grommets were pushing my motherboard up, slightly bending it.
all is good now, had to cut them
Its a snug fight though for sure.
all is good now, had to cut them
Its a snug fight though for sure.
